Ultrasonic Testing of Butt Joints in Electric Steel Plates Using Lamb Waves
Authors:
- 1 January 2023
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Journal of Nondestructive Testing
- Vol. 59 (1) , 11-21
Abstract
The influence of the quality of welding thin steel sheets on the physical and mechanical properties of electric steel has been studied using Lamb waves. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of the plates and in the zone of base metal not affected by thermal influences. Markers of the quality of welded joints are determined. It is established that the most informative parameters are the phase velocity of a Lamb wave and its amplitude. Based on velocity measurements, macroscopic anisotropy of the acoustic properties of the material is found. It is assumed that the origin of this anisotropy is due to residual stresses arising in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt joints in thin steel sheets.Keywords
This publication has 23 references indexed in Scilit:
- Methodological peculiarities of using SH- and Lamb waves when assessing the anisotropy of properties of flatsRussian Journal of Nondestructive Testing, 2016
- The dependence of local deformations and internal stress fields on welding technique for grade VSt3sp structural steel: I. The influence of welding technique on the mechanical characteristics and acoustic emission parameters of grade VSt3sp steelRussian Journal of Nondestructive Testing, 2015
- Ultrasonic estimation of the residual stressesInorganic Materials, 2014
- The ЛИСТ-4 mobile multichannel device for ultrasonic checking of sheetsRussian Journal of Nondestructive Testing, 2014
- Monitoring of Martensitic Transformation in Austenitic Stainless Steel 304 L by Eddy CurrentsResearch in Nondestructive Evaluation, 2010
- Identification of Damage Using Lamb Waves2009
- Eddy current detection of changes in stainless steel after cold reductionComputational Materials Science, 2008
- AISI 304 steel: anomalous evolution of martensitic phase following heat treatments at 400°CMaterials Science and Engineering: A, 2006
- Effects of Strain State and Strain Rate on Deformation-Induced Transformation in 304 Stainless Steel: Part I. Magnetic Measurements and Mechanical BehaviorMetallurgical Transactions A, 1982
- Tensile properties of metastable stainless steelsJournal of Materials Science, 1972