D. Yu. Biryukov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
D. Yu. Biryukov has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Anatoly Fedorovich Zatsepin
Institute of Physics and Technology, Ural Federal University, Ekaterinburg, Russia
2 shared publications A. F Zatsepin
Ural Federal University named after the first President of Russia B.N. Yeltsin
1 shared publicationA. F. Zatsepin
Ural Federal University, Yekaterinburg, Russia
1 shared publicationA. V Vasil'Ev
Ural Federal University named after the first President of Russia B.N. Yeltsin
1 shared publicationA. V. Vasil’EV
Ural Federal University, Yekaterinburg, Russia
1 shared publicationБирюков Д. Ю
Уральский федеральный университет имени первого Президента России Б.Н. Ельцина;Уральский государственный университет путей сообщения
1 shared publication
Latest Publications
- 15 January 2023
- Published by The Russian Academy of Sciences in Defektoskopiâ
- No. 1,p. 14-24
Ultrasonic testing of butt joints in electrotechnical steel plates using Lamb waves
Using Lamb waves, the influence of the welding quality of thin steel sheets on the physical and mechanical properties of electrical steel has been studied. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of plates and in the region of the base metal not affected by thermal effects. Markers of quality of welded joints are determined. It has been established that the most informative parameters are the phase velocity of the Lamb wave and its amplitude. On the basis of velocity measurements, a macroscopic anisotropy of the acoustic properties of the material was found. It is assumed that the origin of this anisotropy is due to residual stresses that arise in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt welds in thin steel sheets.
- 15 January 2023
- Published by The Russian Academy of Sciences in Defektoskopiâ
- No. 1,p. 14-24
Ultrasonic testing of butt joints in electrotechnical steel plates using Lamb waves
Using Lamb waves, the influence of the welding quality of thin steel sheets on the physical and mechanical properties of electrical steel has been studied. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of plates and in the region of the base metal not affected by thermal effects. Markers of quality of welded joints are determined. It has been established that the most informative parameters are the phase velocity of the Lamb wave and its amplitude. On the basis of velocity measurements, a macroscopic anisotropy of the acoustic properties of the material was found. It is assumed that the origin of this anisotropy is due to residual stresses that arise in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt welds in thin steel sheets.
- 1 January 2023
- Published by Pleiades Publishing Ltd in Russian Journal of Nondestructive Testing
- Vol. 59 (1) , 11-21
Ultrasonic Testing of Butt Joints in Electric Steel Plates Using Lamb Waves
The influence of the quality of welding thin steel sheets on the physical and mechanical properties of electric steel has been studied using Lamb waves. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of the plates and in the zone of base metal not affected by thermal influences. Markers of the quality of welded joints are determined. It is established that the most informative parameters are the phase velocity of a Lamb wave and its amplitude. Based on velocity measurements, macroscopic anisotropy of the acoustic properties of the material is found. It is assumed that the origin of this anisotropy is due to residual stresses arising in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt joints in thin steel sheets.
- 1 January 2023
- Published by Pleiades Publishing Ltd in Russian Journal of Nondestructive Testing
- Vol. 59 (1) , 11-21
Ultrasonic Testing of Butt Joints in Electric Steel Plates Using Lamb Waves
The influence of the quality of welding thin steel sheets on the physical and mechanical properties of electric steel has been studied using Lamb waves. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of the plates and in the zone of base metal not affected by thermal influences. Markers of the quality of welded joints are determined. It is established that the most informative parameters are the phase velocity of a Lamb wave and its amplitude. Based on velocity measurements, macroscopic anisotropy of the acoustic properties of the material is found. It is assumed that the origin of this anisotropy is due to residual stresses arising in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt joints in thin steel sheets.
- Open Access
- 24 June 2020
- Published by IntechOpen
Temperature Effects in the Photoluminescence of Semiconductor Quantum Dots
Temperature effects in the exciton photoluminescence specific to semiconductor quantum dots (QDs) are reviewed using Si QDs as an example. The processes of direct and indirect optical excitation of spatially confined excitons in quantum dots embedded in dielectric matrix are analyzed. The temperature behavior of the quantum dots photoluminescence (PL) excited by various methods was described in detail by a generalized electronic transitions scheme using different exciton relaxation models. The different types of temperature dependences were analyzed. The analytical expressions were obtained for their description, which allow one to determine the energy and kinetic characteristics of QD photoluminescence. It was found that the shape of the temperature dependence makes it possible to understand whether the process of exciton relaxation contains several different thermally activated stages or this is a simple one-stage process. The applicability of the obtained expressions for the analysis of the luminescence properties of quantum dots is demonstrated by the example of crystalline and amorphous silicon nanoclusters in silica matrix. It has been established that the quantum confinement effect of excitons in quantum dots leads to a decrease in the frequency characteristics and thermal activation barriers for nonradiative transitions.
- 24 June 2020
- Published by IntechOpen
Open AccessTemperature Effects in the Photoluminescence of Semiconductor Quantum Dots
Temperature effects in the exciton photoluminescence specific to semiconductor quantum dots (QDs) are reviewed using Si QDs as an example. The processes of direct and indirect optical excitation of spatially confined excitons in quantum dots embedded in dielectric matrix are analyzed. The temperature behavior of the quantum dots photoluminescence (PL) excited by various methods was described in detail by a generalized electronic transitions scheme using different exciton relaxation models. The different types of temperature dependences were analyzed. The analytical expressions were obtained for their description, which allow one to determine the energy and kinetic characteristics of QD photoluminescence. It was found that the shape of the temperature dependence makes it possible to understand whether the process of exciton relaxation contains several different thermally activated stages or this is a simple one-stage process. The applicability of the obtained expressions for the analysis of the luminescence properties of quantum dots is demonstrated by the example of crystalline and amorphous silicon nanoclusters in silica matrix. It has been established that the quantum confinement effect of excitons in quantum dots leads to a decrease in the frequency characteristics and thermal activation barriers for nonradiative transitions.
- 19 March 2014
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 56 (3) , 635-638
Analytical temperature dependence of the photoluminescence of semiconductor quantum dots
The excitation and relaxation of spatially confined excitons in semiconductor quantum dots have been considered. The temperature dependence of the luminescence of quantum dots in dielectric matrices...
- 19 March 2014
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 56 (3) , 635-638
Analytical temperature dependence of the photoluminescence of semiconductor quantum dots
The excitation and relaxation of spatially confined excitons in semiconductor quantum dots have been considered. The temperature dependence of the luminescence of quantum dots in dielectric matrices...