Wetting measurements as a tool to predict the thermoplastic/thermoset rubber compatibility in two‐component injection molding
- 27 November 2017
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 135 (13)
Abstract
Recently a novel two‐component injection molding process has been developed combining thermoplastics with thermoset rubbers. Since the adhesion strength between the two materials strongly depends on the combination of a specific thermoplastic and a thermoset rubber, there is a need to predict their compatibility, defined as the formation of a strong interface. In this study, the wetting behavior of molten thermoplastics on rubber substrates is used to predict their compatibility since wetting is an essential step in the formation of a strong interface. Contact angle measurements at high temperatures showed that the wetting of polypropylene and polyethylene is the best in combination with ethylene propylene diene monomer rubber while nitrile rubber is best wetted by polycarbonate. The subsequent two‐component injection molding tests confirm that it is possible to combine these materials. Material combinations with a poor wetting behavior on the other hand are not suitable for two‐component injection molding. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46046.Keywords
This publication has 22 references indexed in Scilit:
- Acting on macrocephaly in the neonatal period: an illustrative case of congenital teratomaBMJ Case Reports, 2014
- Wetting Behavior of Polymer Melts on Bulk Metallic GlassesApplied Mechanics and Materials, 2013
- Understanding the interfacial compatibility and adhesion of natural coir fibre thermoplastic compositesComposites Science and Technology, 2013
- Effect of physical adhesion on mechanical behaviour of bamboo fibre reinforced thermoplastic compositesColloids and Surfaces A: Physicochemical and Engineering Aspects, 2013
- Experimental study on the surface characteristics of polymer meltsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2010
- Comparison of Surface Tension Components and Hansen Solubility Parameters Theories. Part I: Explanation of Protein Adsorption on PolymersJournal of Macromolecular Science, Part B, 2010
- Adhesion of polymersProgress in Polymer Science, 2009
- Unsteady-state contact angle on interface between polymer melt and TiO2Composite Interfaces, 2008
- Polymer-Polymer Interdiffusion and AdhesionJournal of Macromolecular Science, Part C: Polymer Reviews, 1994
- The history of the spreading coefficientJournal of Colloid and Interface Science, 1992