In Situ Electrochemical Treatment Evoked Superior Grain Growth for Green Electrodeposition-Processed Flexible CZTSe Solar Cells
Authors:
- 1 July 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (27) , 31852-31860
Abstract
Flexible Cu2ZnSnSe4 (CZTSe) solar cells gradually attract much attention due to their low-cost, lightweight, and environmentally friendly features. However, the efficiency of flexible CZTSe solar cells obtained through the nonvacuum green electrodeposition process remains sluggish (3.82%), far away from that obtained from other methods (∼10% by magnetron sputtering). Herein, a championed 6.33% efficiency of flexible CZTSe solar cells prepared by the electrodeposition process is achieved through an in situ electrochemical treatment (ET) process. It is found that the ET process drives the formation of a thin MoOx layer, evoking a series of beneficial results, thus accounting for an enhancement in photovoltaic performance. With the ET process, the MoSe2 thickness is compressed and Cu- and Sn-related undesirable defects/secondary phases are inhibited, leading to improved film quality. Additionally, it prolongs the depletion region width and minority lifetime, accelerates the charge separation and collection, relieves the band tails, and favorably reverses the band bending from downward to upward at/near grain boundaries. With these effects, the efficiency increases from 4.21% to 6.33%, far beyond the highest reports on electrodeposited flexible CZTSe solar cells. Our findings offer a promising way to improving Mo foil-based flexible devices and mark a significant breakthrough for the development of electrodeposition-processed flexible CZTSSe-based solar cells.Keywords
Funding Information
- Education Department of Henan Province (19A480004)
- National Natural Science Foundation of China (61804045, U1804160)
This publication has 52 references indexed in Scilit:
- Modification of Back Contact in Cu2ZnSnS4 Solar Cell by Inserting Al-Doped ZnO Intermediate LayerACS Applied Materials & Interfaces, 2020
- Defect suppression in multinary chalcogenide photovoltaic materials derived from kesterite: progress and outlookJournal of Materials Chemistry A, 2020
- Persistent Double-Layer Formation in Kesterite Solar Cells: A Critical ReviewACS Applied Materials & Interfaces, 2020
- Sn4+ precursor enables 12.4% efficient kesterite solar cell from DMSO solution with open circuit voltage deficit below 0.30 VScience China Materials, 2020
- Effect of Cu–Sn–Se Liquid Phase on Grain Growth and Efficiency of CZTSSe Solar CellsAdvanced Energy Materials, 2020
- Effect of solid-H 2 S gas reactions on CZTSSe thin film growth and photovoltaic properties of a 12.62% efficiency deviceJournal of Materials Chemistry A, 2019
- Flexible Cu2ZnSn(S,Se)4 solar cells with over 10% efficiency and methods of enlarging the cell areaNature Communications, 2019
- Cu2ZnSnS4 solar cells with over 10% power conversion efficiency enabled by heterojunction heat treatmentNature Energy, 2018
- Defect Engineering in Multinary Earth‐Abundant Chalcogenide Photovoltaic MaterialsAdvanced Energy Materials, 2017
- Device Characteristics of CZTSSe Thin‐Film Solar Cells with 12.6% EfficiencyAdvanced Energy Materials, 2013