Cavity Air Flow Behavior During Filling in Microinjection Molding
- 24 January 2011
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 133 (1) , 011006
Abstract
Process monitoring of microinjection molding is of crucial importance in understanding the effects of different parameter settings on the process, especially on its performance and consistency with regard to parts’ quality. Quality factors related to mold cavity air evacuation can provide valuable information about the process dynamics and also about the filling of a cavity by a polymer melt. In this paper, a novel experimental setup is proposed to monitor maximum air flow and air flow work as an integral of the air flow over time by employing a microelectromechanical system gas sensor mounted inside the mold. The influence of four parameters, melt temperature, mold temperature, injection speed, and resistance to air evacuation, on two air flow-related output parameters is investigated by carrying out a design of experiment study. The results provide empirical evidences about the effects of process parameters on cavity air evacuation, and the influence of air evacuation on the part flow length.
Keywords
This publication has 33 references indexed in Scilit:
- Some recent advances in multi-material micro- and nano-manufacturingThe International Journal of Advanced Manufacturing Technology, 2009
- Study of process parameters effect on the filling phase of micro-injection moulding using weld lines as flow markersThe International Journal of Advanced Manufacturing Technology, 2009
- The finite element analysis of melt flow behaviour in micro-injection mouldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2008
- Editorial for the special issue of IJAMT on multi material microsystem manufacturingThe International Journal of Advanced Manufacturing Technology, 2007
- The manufacturing of micro molds by conventional and energy-assisted processesThe International Journal of Advanced Manufacturing Technology, 2006
- Micro-injection moulding: Factors affecting the achievable aspect ratiosThe International Journal of Advanced Manufacturing Technology, 2006
- A roadmapping study in Multi-Material Micro Manufacture2006
- Scaling Issues in Miniaturization of Injection Molded PartsJournal of Manufacturing Science and Engineering, 2004
- Micro EngineeringCIRP Annals, 2003
- Performance and simulation of thermoplastic micro injection moldingMicrosystem Technologies, 2002