From Ocean Waste to Injection-Molded Parts: Assessing the Manufacturing with Recycled Fishing Nets
Open Access
- 18 August 2026
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 18 (16) , 8442
Abstract
Plastic production and consumption have increased substantially due to the favorable properties of these materials, raising significant environmental concerns because most plastics do not fully decompose. A substantial portion of ocean plastic waste comes from ghost gear, including abandoned fishing nets. In this context, mechanical recycling offers a promising route for recovering these materials and reducing their environmental impact. This study evaluates the feasibility of using recycled fishing nets made of polyamide 6 (PA6) to manufacture injection-molded parts. Injection-molded specimens produced from recycled fishing nets were descriptively compared with specimens obtained from commercially available extruded PA6 plates, used as a commercial processing reference. Both materials were also subjected to an additional post-injection mechanical recycling cycle to evaluate short-term property retention after reprocessing. The feasibility of producing cardholders by injection molding was also examined as a proof of concept. Physical and mechanical characterization showed that the recycled fishing-net PA6 exhibited higher average yield stress and Young’s modulus, but lower stress and strain at break and lower impact toughness than the commercial PA6 reference. The second recycling cycle did not produce a consistent deterioration across the measured properties, although statistical equivalence between the two recycling conditions was not established. The successful production and assembly of cardholders demonstrated the laboratory-scale processability of recovered fishing-net PA6, while further characterization, additional recycling cycles, and process optimization are required to assess long-term recyclability and industrial viability.Keywords
Funding Information
- Fundação para a Ciência e a Tecnologia (UID/50022/2025)
- Missão Interface–renovação da rede de suporte científico e tecnológico e orientação para o tecido produtivo (PRR-RE-C05-i02)
This publication has 31 references indexed in Scilit:
- Microbial degradation behavior and mechanism of polyamide 6 fibers in seawaterPolymer Degradation and Stability, 2025
- Polyamide recycling by selective dissolution approach: Life Cycle Assessment study and environmental impacts comparison with different recycling technologiesPolymer Engineering & Science, 2025
- Mechanical behavior of polyamide-6 after combined photo-oxidative and hygrothermal agingColloid and Polymer Science, 2023
- Environmental impacts of synthetic fishing nets from manufacturing to disposal: A case study of Türkiye in life cycle perspectiveMarine Pollution Bulletin, 2023
- End-of-life fishing gear in Spain: Quantity and recyclabilityEnvironmental Pollution, 2022
- Modified recycled polyamide 6,6 (r-PA 6,6) based on pelagic fishing nets and their physical propertiesJournal of the Indian Chemical Society, 2022
- Microplastics in aquatic environment: Challenges and perspectivesChemosphere, 2021
- Thermomechanical recycling of polyamide 6 from fishing nets wasteJournal of Applied Polymer Science, 2019
- Technologies for the marking of fishing gear to identify gear components entangled on marine animals and to reduce abandoned, lost or otherwise discarded fishing gearMarine Pollution Bulletin, 2018
- On North Pacific circulation and associated marine debris concentrationMarine Pollution Bulletin, 2012