Experimental and Numerical Analysis of Flow Force Acting on the Spool of Proportional Directional Valve
Open Access
- 13 December 2023
- Vol. 11 (12) , 3415
Abstract
This paper deals with the experimental and numerical analysis of the flow force acting on the spool of a proportional directional valve. The flow force arises due to the fluid flow through the flow path of the proportional directional valve and significantly influences the dynamics of the valve spool. The valve under investigation is a three-position four-way proportional directional valve with zero spool lap and feedback from the spool position. The dependence of the valve spool flow force on the volumetric flow rate is measured as part of the experiment. The measurements are performed for different spool displacements. The measured data will be used to verify the numerical simulations. The proportional directional valve was modified so that a force sensor could be included on the spool axis to realize the experiment. Firstly, the flow force is measured as the fluid passes through the two flow paths of the valve (PB and AT). Subsequently, the experimental setup is modified to determine the flow force when the fluid passes through each flow path separately. The measurements are compared. Simulations of the flow through the proportional directional valve are performed using Ansys Fluent 2022 R2 software to determine the flow forces acting on the valve spool. Simulations are performed for the selected spool positions of the proportional directional valve. Finally, the results of the simulation and the experiment are compared. The contribution of this study is a CFD model of the flow paths of the proportional directional valve verified by experiment. The CFD model will allow the flow force analysis for different flow path geometries of the investigated valve. Experimental analysis of flow force is performed over the entire spool stroke at different volumetric flow rates. The flow forces are measured for each flow path separately and for both flow paths simultaneously.Keywords
Funding Information
- European Regional Development Fund in the Research Centre of Advanced Mechatronic Systems project (CZ.02.1.01/0.0/0.0/16_019/0000867, SP2023/015)
- SGS (CZ.02.1.01/0.0/0.0/16_019/0000867, SP2023/015)
- Experimental methods for fluid mechanisms mathematical models verification (CZ.02.1.01/0.0/0.0/16_019/0000867, SP2023/015)
This publication has 16 references indexed in Scilit:
- Characteristics Analysis of the Pilot-Operated Proportional Directional Valve by Experimental and Numerical InvestigationEnergies, 2022
- Flow force research and structure improvement of cartridge valve core based on CFD methodHeliyon, 2022
- Numerical and experimental analysis of fluid force for nuclear valveInternational Journal of Mechanical Sciences, 2022
- The Use of a Model-Based Controller for Dynamics Improvement of the Hydraulic Drive with Proportional Valve and Synchronous MotorEnergies, 2022
- A Case Study of Open- and Closed-Loop Control of Hydrostatic Transmission with Proportional Valve Start-Up ProcessEnergies, 2022
- Steady Flow Force Compensation and Test Research on Electrohydraulic Proportional Relief ValveIEEE Access, 2019
- Analysis of Flow forces in the initial phase of throttle gap opening in a proportional control valveFlow Measurement and Instrumentation, 2018
- The importance of a full 3D fluid dynamic analysis to evaluate the flow forces in a hydraulic directional proportional valveEngineering Computations, 2014
- Three dimensional CFD analysis and experimental test of flow force acting on the spool of solenoid operated directional control valveEnergy Conversion and Management, 2013
- Flow forces analysis of an open center hydraulic directional control valve sliding spoolEnergy Conversion and Management, 2006