Surface Enhancement of CoCrMo Bioimplant Alloy via Nanosecond and Femtosecond Laser Processing with Thermal Treatment
Open Access
Abstract
With an aging population, the number of joint replacement surgeries is on the rise. One of the most common implant materials is cobalt–chromium–molybdenum (CoCrMo) alloy. Hence, the surface properties of this alloy have attracted increasing attention. In this study, nanosecond and femtosecond laser processing, followed by annealing, was employed to modify the CoCrMo surface. The effects of the treatment conditions on the surface morphology, structure, composition, hardness, roughness, contact angle, wear properties, and corrosion current were studied. Femtosecond laser processing with an energy density of 1273 mJ/cm2, followed by heat treatment at 160 °C for 2 h, produced laser-induced periodic surface structures (LIPSS) without altering the chemical composition of the alloy and rendered the surface superhydrophobic. In contrast, nanosecond laser treatment at higher laser energy densities promoted the formation of an oxide layer, which improved the hardness and corrosion resistance of the substrate. Overall, the CoCrMo samples processed using the femtosecond laser system exhibited superior corrosion and wear resistance, with a protection efficiency of approximately 92%.Keywords
Funding Information
- National Science and Technology Council, ROC (NSTC 114-2221-E-020-016)
This publication has 37 references indexed in Scilit:
- XPS Study of Co28Cr6Mo Biocompatible AlloySurface and Interface Analysis, 2025
- Understanding the effect of oxide accumulation on femtosecond laser machining of nickel-based superalloy alloyApplied Surface Science, 2025
- Effects of laser patterning and heat treatment on hydrophobicity, wear, and corrosion resistance of 316L stainless steelThe International Journal of Advanced Manufacturing Technology, 2025
- Superior wear resistance in cast aluminum alloy via femtosecond laser induced periodic surface structures and surface hardening layerApplied Surface Science, 2023
- Research on the mechanism of DD6 single crystal superalloy wear resistance improvement by femtosecond laser modificationApplied Surface Science, 2022
- Fast wettability transition from hydrophilic to superhydrophobic laser-textured stainless steel surfaces under low-temperature annealingApplied Surface Science, 2017
- The stability of DLC film on nitrided CoCrMo alloy in phosphate buffer solutionApplied Surface Science, 2014
- Microstructural effects on the wear resistance of wrought and as‐cast Co‐Cr‐Mo‐C implant alloysJournal of Biomedical Materials Research Part A, 2005
- Recent metallic materials for biomedical applicationsMetallurgical and Materials Transactions A, 2002
- Femtosecond, picosecond and nanosecond laser ablation of solidsApplied Physics A, 1996