Yu-Ming Ding
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yu-Ming Ding has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Hsuan-Kai Lin
Department of Materials Engineering, National Pingtung University of Science and Technology, Pingtung, Taiwan
1 shared publication - Po-Wei Chang
Department of Materials Engineering, National Pingtung University of Science and Technology, Pingtung 912, Taiwan
1 shared publication - Wei-Hua Lu
Department of Material Engineering, National Pingtung University of Science and Technology, Pingtung 91201, Taiwan
1 shared publication - Yu-Ting Lyu
Metal Industries Research & Development Centre, Kaohsiung, Taiwan
1 shared publication - Yuan-Jen Chang
Department of Mechanical Engineering, National Yunlin University of Science and Technology, Douliou, Yunlin 64002, Taiwan
1 shared publication
Latest Publications
- Open Access
Surface Enhancement of CoCrMo Bioimplant Alloy via Nanosecond and Femtosecond Laser Processing with Thermal Treatment
With an aging population, the number of joint replacement surgeries is on the rise. One of the most common implant materials is cobalt–chromium–molybdenum (CoCrMo) alloy. Hence, the surface properties of this alloy have attracted increasing attention. In this study, nanosecond and femtosecond laser processing, followed by annealing, was employed to modify the CoCrMo surface. The effects of the treatment conditions on the surface morphology, structure, composition, hardness, roughness, contact angle, wear properties, and corrosion current were studied. Femtosecond laser processing with an energy density of 1273 mJ/cm2, followed by heat treatment at 160 °C for 2 h, produced laser-induced periodic surface structures (LIPSS) without altering the chemical composition of the alloy and rendered the surface superhydrophobic. In contrast, nanosecond laser treatment at higher laser energy densities promoted the formation of an oxide layer, which improved the hardness and corrosion resistance of the substrate. Overall, the CoCrMo samples processed using the femtosecond laser system exhibited superior corrosion and wear resistance, with a protection efficiency of approximately 92%.
Open AccessSurface Enhancement of CoCrMo Bioimplant Alloy via Nanosecond and Femtosecond Laser Processing with Thermal Treatment
With an aging population, the number of joint replacement surgeries is on the rise. One of the most common implant materials is cobalt–chromium–molybdenum (CoCrMo) alloy. Hence, the surface properties of this alloy have attracted increasing attention. In this study, nanosecond and femtosecond laser processing, followed by annealing, was employed to modify the CoCrMo surface. The effects of the treatment conditions on the surface morphology, structure, composition, hardness, roughness, contact angle, wear properties, and corrosion current were studied. Femtosecond laser processing with an energy density of 1273 mJ/cm2, followed by heat treatment at 160 °C for 2 h, produced laser-induced periodic surface structures (LIPSS) without altering the chemical composition of the alloy and rendered the surface superhydrophobic. In contrast, nanosecond laser treatment at higher laser energy densities promoted the formation of an oxide layer, which improved the hardness and corrosion resistance of the substrate. Overall, the CoCrMo samples processed using the femtosecond laser system exhibited superior corrosion and wear resistance, with a protection efficiency of approximately 92%.