Drifts effect on the divertor W leakage mechanisms under different dissipative divertor conditions of EAST
Open Access
- 23 February 2024
- journal article
- research article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (4) , 046009
Abstract
A new drift module has been developed in the DIVIMP code, enabling two-dimensional simulations of tungsten (W) transport in the edge plasma with full drifts included. By using the SOLPS-DIVIMP code package, the impact of drifts on W transport and screening has been investigated for various levels of dissipative divertor conditions and different divertor geometric configurations in EAST. Simulation results reveal that E ⃗ × B ⃗ drifts can enhance the W leakage by more than one order of magnitude. Under the favorable Bt direction, W erosion mainly occurs on the outer divertor target, making the W leakage from the outer divertor region the dominator. A leakage path from the near-scrape-off layer (SOL) region is revealed by the modeling results. In the leakage path, both the ion temperature gradient force and the reversed poloidal E ⃗ × B ⃗ drift are pointing upstream. With the radial E ⃗ × B ⃗ drift pushing W ions from the well-screened far-SOL region to the near-SOL region, the leakage from the near-SOL region becomes significant. As the divertor condition varies from the low-recycling regime to the deep detachment regime, the decrease of the ion temperature gradient velocity and poloidal E ⃗ × B ⃗ drift velocity narrows the width of the near-SOL leakage tunnel and thus enhances W screening. While under the unfavorable Bt , W erosion and leakage from the inner divertor target matters, the leakage mechanism especially the leakage path from the near-SOL region is similar as the favorable Bt cases. Furthermore, the effect of different divertor geometries on the W screening has been investigated. The configuration with the outer strike point (OSP) on the horizontal divertor plate is proved to narrow the near-SOL leakage tunnel, and thus the unreversed poloidal E ⃗ × B ⃗ drift pointing to the divertor target dominates and helps to enhance the divertor W screening. For the same D 2 puffing rate, the W leakage ability of cases with the OSP on the horizontal target can be more than 10 times weaker than the cases with the OSP on the vertical target, especially when the divertor is detached.Keywords
Funding Information
- Key Research Program of Frontier Sciences of CAS (ZDBS-LY-SLH010)
- National MCF Energy R&D Program of China (2019YFE03080100)
- National Natural Science Foundation of China (12005143)
This publication has 35 references indexed in Scilit:
- The effect of divertor closure on detachment onset in DIII-DNuclear Materials and Energy, 2019
- European divertor target concepts for DEMO: Design rationales and high heat flux performanceNuclear Materials and Energy, 2018
- Advanced materials for a damage resilient divertor concept for DEMO: Powder-metallurgical tungsten-fibre reinforced tungstenFusion Engineering and Design, 2017
- Experimentally-based ExB drifts in the DIII-D divertor and SOL calculated from integration of Ohm's law using Thomson scattering measurements of Te and neNuclear Materials and Energy, 2017
- Comparison of 2D simulations of detached divertor plasmas with divertor Thomson measurements in the DIII-D tokamakNuclear Materials and Energy, 2017
- Use of tungsten material for the ITER divertorNuclear Materials and Energy, 2016
- Effects of background plasma characteristics on tungsten impurity transport in the SOL/divertor region using IMPGYRO codeJournal of Nuclear Materials, 2015
- Comparison of kinetic and fluid models for tungsten impurity transport using IMPGYRO and SOLPSJournal of Nuclear Materials, 2013
- Development of divertor tungsten coatings for the JET ITER-like wallJournal of Nuclear Materials, 2009
- Plasma Edge Physics with B2‐EireneContributions to Plasma Physics, 2006