Defect engineering via Ag and Na Co-doping in wide-bandgap CIGS: from interfacial suppression to bulk enhancement
Open Access
- 23 October 2025
- journal article
- Published by IOP Publishing in Materials Futures
- Vol. 4 (4) , 045105
Abstract
The efficiency of wide-bandgap (WBG) CIGS solar cells is restricted by bulk quality degradation and severe heterojunction interface recombination, resulting in high V oc loss and suboptimal fill factor (FF). Although Ag doping has proven effective in enhancing WBG performance, its synergistic mechanisms with monovalent Na dopants remain poorly understood. This study systematically investigates the cooperative effects of Ag–Na co-doping. The key findings reveal that both dopants reduce the Fermi level and enhance the built-in potential, albeit through distinct pathways: Na increases carrier concentration but concurrently raises interface defect density. In contrast, Ag improves lattice ordering and reduces point defects through isoelectronic substitution at Cu sites to suppress interfacial defects and reduce recombination losses. Although Ag–Na co-doping improves both V oc and FF, excessive Na incorporation introduces oversized conduction band offset (CBO) barriers, degrading device performance. To address this concern, we propose an Na-depletion strategy (30% lower than the standard Ag-alloyed CIGS Na baseline) under Ag doping, achieving a balanced optimization of bulk carrier transport and interfacial band alignment. The optimized device demonstrates a V oc of 801.4 mV, J sc of 27.3 mA cm −2 , FF of 71.3%, and a champion PCE of 15.6%, providing a viable pathway for high-performance WBG CIGS development. Notably, the resulting bandgap energy (1.36 eV) closely aligns with the Shockley–Queisser model optimum.Keywords
Funding Information
- National Natural Science Foundation of China (52173243)
- SIAT-CUHK Joint Laboratory of Photovoltaic Solar Energy
- National Key Research and Development Program of China (2024YFB4205300)
- Shenzhen Basic Research (JCYJ20210324115406019)
This publication has 47 references indexed in Scilit:
- Achieving over 860 mV Open‐Circuit Voltage in Low‐Ag Wide‐Bandgap Cu(In,Ga)Se2 Solar Cells Through Ion Diffusion and Band Structure OptimizationAdvanced Functional Materials, 2025
- Over 100 mV VOC Improvement for Rear Passivated ACIGS Ultra‐Thin Solar CellsAdvanced Functional Materials, 2023
- Effect of Na‐PDT and KF‐PDT on the photovoltaic performance of wide bandgap Cu (In,Ga)Se2 solar cellsProgress in Photovoltaics: Research and Applications, 2020
- Wide‐gap (Ag,Cu)(In,Ga)Se2 solar cells with different buffer materials—A path to a better heterojunctionProgress in Photovoltaics: Research and Applications, 2020
- Secondary phase formation and surface modification from a high dose KF‐post deposition treatment of (Ag,Cu)(In,Ga)Se2solar cell absorbersProgress in Photovoltaics: Research and Applications, 2018
- Record 1.0 V open‐circuit voltage in wide band gap chalcopyrite solar cellsProgress in Photovoltaics: Research and Applications, 2017
- Influence of Na on grain boundary and properties of Cu(In,Ga)Se2 solar cellsProgress in Photovoltaics: Research and Applications, 2017
- Structural tuning of wide-gap chalcopyrite CuGaSe2 thin films and highly efficient solar cells: differences from narrow-gap Cu(In,Ga)Se2Progress in Photovoltaics: Research and Applications, 2014
- Wide bandgap Cu(In,Ga)Se2solar cells with improved energy conversion efficiencyProgress in Photovoltaics: Research and Applications, 2012
- A stacked chalcopyrite thin‐film tandem solar cell with 1.2 V open‐circuit voltageProgress in Photovoltaics: Research and Applications, 2003