Evaluation of Polymerization Shrinkage, Microhardness, and Depth of Cure of Different Types of Bulk‐Fill Composites
Open Access
- 29 March 2025
- journal article
- Published by Wiley in Journal of Esthetic and Restorative Dentistry
- Vol. 37 (7) , 1920-1929
Abstract
Objectives: This study aimed to quantify polymerization shrinkage, microhardness, and depth of cure of different types of bulk‐fill composites. Methods: Six bulk‐fill composites were tested: SonicFill 2 (SCF), VisCalor (VVC), Admira Fusion x‐tra (AFX), Filtek Bulk Fill (FBF), Fill‐Up! (FUP) and GrandioSO Heavy Flow (GHF). Sixty teeth were divided into twelve groups ( n = 5) according to the composite and the irradiation level applied (standard or high). Each tooth was subjected to three scans using a micro‐computed tomography device. The microhardness of the composite specimens was measured using a Vickers hardness tester. Depth of cure analysis was performed by measuring the microhardness of the composites at 0.5 mm intervals from the top surface to the bottom surface. Results: The highest volumetric shrinkage was found in the AFX group when polymerized at standard irradiance. After curing, the AFX group showed the highest void ratio. Increasing irradiance significantly increased volumetric shrinkage and void ratio only in the SCF group ( p < 0.05). GHF achieved the maximum microhardness value of 80% at the lowest curing depth of 2.9 mm, while VVC, AFX, and SCF showed a curing depth of more than 5 mm ( p < 0.05). Conclusions: The high irradiance caused the most significant volumetric shrinkage and void ratio in the SCF group. Only the FUP and GHF groups were unable to achieve the desired curing depth of 4 mm. Clinical Relevance: Irradiance, material types, and thickness are important factors in the polymerization of composites.Keywords
Funding Information
- Akdeniz Üniversitesi
This publication has 42 references indexed in Scilit:
- Marginal integrity and physicomechanical properties of a thermoviscous and regular bulk-fill resin compositesClinical Oral Investigations, 2024
- Micro‐computed tomography evaluation of internal void formation of bulk‐fill resin composites in Class II restorationsPolymer Composites, 2018
- Polymerization shrinkage assessment of dental resin composites: a literature reviewOdontology, 2016
- Shrinkage assessment of low shrinkage composites using micro-computed tomographyJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2014
- High-resolution tomography study of the porosity of three restorative resin compositesClinical Oral Investigations, 2013
- Effects of particle size of silica filler on polymerization conversion in a light-curing resin compositeDental Materials, 2011
- BisGMA/TEGDMA ratio and filler content effects on shrinkage stressDental Materials, 2011
- Factors involved in the development of polymerization shrinkage stress in resin-composites: A systematic reviewDental Materials, 2005
- Porosity in composite resinsBiomaterials, 1995
- The direct examination of three-dimensional bone architecture in vitro by computed tomographyJournal of Bone and Mineral Research, 1989