Studies on impact‐modified nylon 6/ABS blends
Authors:
- 24 November 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (12) , 2340-2345
Abstract
The objective of this research is to study the effect of using maleic anhydride‐grafted polyethylene‐octene elastomer (POE‐g‐MA) as a compatibilizer on nylon 6/acrylonitile‐butadiene‐styrene (ABS) copolymer blends. With POE‐g‐MA, nylon 6/ABS at a blending ratio of 80/20 showed an optimal result in modified impact property. Scanning electron microscopy (SEM) revealed that the particle sizes of ABS in the dispersed phase diminished as the amount of the added compatibilizer (POE‐g‐MA) increased. The compatibilizer reduced the surface tension between nylon 6 and ABS, thus increasing the compatibility of the two phases. Furthermore, studies of the rheological behavior of the system showed that the shear viscosity of nylon 6/ABS blends also increased with the introduction of POE‐g‐MA. Finally, dynamic mechanical analysis (DMA) experiments showed that adding POE‐g‐MA dramatically improved the impact strength of the blends at room temperature and low temperatures. Polym. Eng. Sci. 44:2340–2345, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 7 references indexed in Scilit:
- Thermal, mechanical, and diffusional properties of nylon 6/ABS polymer blends: Compatibilizer effectPolymer Engineering & Science, 2000
- Impact fracture morphology of nylon 6 toughened with a maleated polyethylene-octene elastomerJournal of Applied Polymer Science, 2000
- Influence of interfacial adhesion on toughening of polyethylene-octene elastomer/nylon 6 blendsJournal of Applied Polymer Science, 1998
- Toughening of nylon 6 with a maleated core-shell impact modifierJournal of Polymer Science Part B: Polymer Physics, 1998
- Morphology of nylon 6/ABS blends compatibilized by a styrene/maleic anhydride copolymerPolymer, 1994
- Morphological, thermal, and rheological properties of nylon/acrylonitrile‐butadiene‐styrene alloysPolymer Engineering & Science, 1992
- Reactive compatibilization of blends of nylon 6 and ABS materialsPolymer, 1991