Filament winding of aramid/PA6 commingled yarns with in situ consolidation
- 19 May 2017
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 31 (4) , 465-482
Abstract
The in situ consolidation of commingled yarns during filament winding is demonstrated on an aramid fibre-reinforced polyamide 6 material. This article is a systematic experimental investigation of the filament winding processing parameters, namely, the heat gun temperature, line speed, fibre tension, compaction force and preheater temperature. Optimizing the processing parameters in this filament winding process produced a fully consolidated material with a void content of ∼0.25% which is comparable to the material quality achieved by means of compression moulding using the same intermediate materials.Keywords
This publication has 22 references indexed in Scilit:
- Anisogrid composite lattice structures for spacecraft and aircraft applicationsComposite Structures, 2006
- Thermal Phenomena in Fiber-reinforced Thermoplastic Tape Winding Process: Computational Simulations and Experimental ValidationsJournal of Composite Materials, 2004
- New generation of filament-wound composite pressure vessels for commercial applicationsComposite Structures, 2003
- Thermoplastic filament winding with online-impregnation. Part B. Experimental study of processing parametersComposites Part A: Applied Science and Manufacturing, 2002
- Thermoplastic filament winding with online-impregnation. Part A: process technology and operating efficiencyComposites Part A: Applied Science and Manufacturing, 2002
- An Experimental Study on the Thermoplastic Filament Winding Process using Commingled YarnsAdvanced Composites Letters, 2002
- Analysis of filament wound composite structures considering the change of winding angles through the thickness directionComposite Structures, 2002
- Analysis of multi-layered filament-wound composite pipes under internal pressureComposite Structures, 2001
- Influence of filament winding parameters on composite vessel quality and strengthComposites Part A: Applied Science and Manufacturing, 1997
- Determination of Manufacturing Conditions for Hot-Gas-Aided Thermoplastic Tape WindingJournal of Thermoplastic Composite Materials, 1996