A Fast T&H Overcurrent Detector for a Spinning Hall Current Sensor With Ping-Pong and Chopping Techniques
Authors:
- 25 April 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 54 (7) , 1852-1861
Abstract
This paper presents a fast spinning-current Hall sensor with 568 ns overall delay for sub-microsecond overcurrent detection (OCD) in a magnetic current sensor. By combining the continuous-time chopping techniques and discrete-time dynamic offset cancellation techniques, the spinning frequency of 250 kHz does not limit the sensor speed. The proposed track-and-hold (T&H) ping-pong comparators extend the usage of auto-zeroing techniques for sensor interface applications. The design achieves a magnetic residual offset of 85 μT (mean) and 79 μT (1σ ), while the offset drifts only 0.68 μT/°C (mean) and 0.27 μT/°C (1σ ) from -40 °C to 150 °C. In addition, a background switched-capacitor filter breaks the limitation of high-frequency errors on conventional correlated double sampling techniques. The design thus reduces the input-referred noise to 136 μTrms with a bandwidth of 1.7 MHz, while consuming at least 30% less power than the other state-of-the-art designs. Moreover, the analog stress compensation with temperature coefficient (TC) correction guarantees an overall threshold error within ± 4% over package stress and temperature.Keywords
This publication has 28 references indexed in Scilit:
- A Fully Integrated Analog Compensation for the Piezo-Hall Effect in a CMOS Single-Chip Hall Sensor MicrosystemIEEE Sensors Journal, 2014
- A Continuous-Time Ripple Reduction Technique for Spinning-Current Hall SensorsIEEE Journal of Solid-State Circuits, 2014
- A 1.8 $\mu$W 60 nV$/\surd$Hz Capacitively-Coupled Chopper Instrumentation Amplifier in 65 nm CMOS for Wireless Sensor NodesIEEE Journal of Solid-State Circuits, 2011
- Micro-Hall devices: performance, technologies and applicationsSensors and Actuators A: Physical, 2003
- Chopper-stabilized amplifiers with a track-and-hold signal demodulatorIEEE Transactions on Circuits and Systems I: Regular Papers, 1999
- Monolithic magnetic Hall sensor using dynamic quadrature offset cancellationIEEE Journal of Solid-State Circuits, 1997
- Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilizationProceedings of the IEEE, 1996
- An automatic offset compensation scheme with ping-pong control for CMOS operational amplifiersIEEE Journal of Solid-State Circuits, 1994
- A low-offset spinning-current hall plateSensors and Actuators A: Physical, 1990
- Response of a correlated double sampling circuit to 1/f noise [generated in CCD arrays]IEEE Journal of Solid-State Circuits, 1980