On the non‐iterative procedure of direct displacement‐based seismic design for portal R.C. bridges: Using inelastic design spectrum
Authors:
- 4 March 2005
- journal article
- research article
- Published by Taylor & Francis in Journal of the Chinese Institute of Engineers
- Vol. 28 (2) , 293-303
Abstract
In general, iterative procedures are required by the direct displacement‐based seismic design method. This paper presents a non‐iterative displacement‐based method for the design of portal R.C. bridges based on the inelastic design response spectrum. By combining the properties of structural stiffness and yielding, a rational, efficient and accurate method is established, where not only the strength and stiffness of members depend on the pre‐selected target displacement and ductility ratio, but the cross‐sections of those can also directly be determined form the two pre‐chosen values without any iteration. In addition to the examples that are used to illustrate the proposed procedure, the dynamic inelastic time history analysis and the static nonlinear analysis (pushover analysis) are also included to verify this procedure. It is concluded by the study that iterations are not needed in direct displacement‐based design if the force‐deformation relationships of designed structures can be derived.Keywords
This publication has 10 references indexed in Scilit:
- Displacement‐based seismic design for buildingsJournal of the Chinese Institute of Engineers, 2002
- Performance-based design in earthquake engineering: a multi-disciplinary reviewEngineering Structures, 2001
- Direct Displacement‐Based Design: Use of Inelastic vs. Elastic Design SpectraEarthquake Spectra, 2001
- Direct displacement-based seismic design of concrete buildingsBulletin of the New Zealand Society for Earthquake Engineering, 2000
- Capacity spectrum method based on inelastic demand spectraEarthquake Engineering & Structural Dynamics, 1999
- DISPLACEMENT-BASED SEISMIC ASSESSMENT OF REINFORCED CONCRETE BUILDINGSJournal of Earthquake Engineering, 1997
- Displacement‐based seismic design of multi‐degree‐of‐freedom bridge structuresEarthquake Engineering & Structural Dynamics, 1995
- Seismic Design of RC Structural Walls. Part I: New Code FormatJournal of Structural Engineering, 1995
- 6. Evaluation of Strength Reduction Factors for Earthquake‐Resistant DesignEarthquake Spectra, 1994
- 5. Displacement‐Based Design of RC Structures Subjected to EarthquakesEarthquake Spectra, 1992