Filter Design for Cable Overvoltage and Power Loss Minimization in a Tidal Energy System With Onshore Converters
- 12 May 2015
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Sustainable Energy
- Vol. 7 (1) , 400-408
Abstract
By moving the back-to-back ac-dc-ac converters in a tidal current conversion system (TCCS) onshore, maintenance requirements and cost are reduced significantly. This is because underwater components are not easily accessible and operate in a harsh environment. In addition to increased maintainability, the concept of long-distance controls offers maximum power capture from the tidal currents in the same way that a converter in the nacelle would offer. However, a number of challenges are associated with the concept of controlling electrical machines through long cables, which include electromagnetic traveling waves in the cables and system resonance. These phenomena can induce overvoltages at the generator terminals which can lead to system failure and high harmonics that can induce extra power losses. The major contribution of this paper is a new method of filter design for systems with long-distance controls and for minimization of system power loss. The proposed method is validated by developing a full resource-to-grid TCCS in MATLAB/Simulink. Simulation results show that using the proposed method, overvoltage mitigation can be achieved in the same way as literature-based filters, but at the same time, minimize the total system losses. The results from the analysis can be used to optimize tidal energy conversion systems with a similar electrical configuration.Keywords
Funding Information
- Andritz Hydro Hammerfest
- University of Edinburgh
This publication has 16 references indexed in Scilit:
- Modelling and Control of Tidal Energy Conversion Systems with Long Distance Converters2014
- Performance of Pitch and Stall Regulated Tidal Stream TurbinesIEEE Transactions on Sustainable Energy, 2013
- Transient Cable Overvoltage Calculation and Filter Design: Application to Onshore Converter Station for Hydrokinetic Energy HarvestingIEEE Transactions on Power Delivery, 2013
- Power Smoothing Control in a Grid-Connected Marine Current Turbine System for Compensating Swell EffectIEEE Transactions on Sustainable Energy, 2013
- Fault-Tolerant Control Performance Comparison of Three- and Five-Phase PMSG for Marine Current Turbine ApplicationsIEEE Transactions on Sustainable Energy, 2012
- Experimental Validation of a Marine Current Turbine Simulator: Application to a Permanent Magnet Synchronous Generator-Based System Second-Order Sliding Mode ControlIEEE Transactions on Industrial Electronics, 2010
- High-Order Sliding Mode Control of a Marine Current Turbine Driven Doubly-Fed Induction GeneratorIEEE Journal of Oceanic Engineering, 2010
- Modelling and control of a marine current turbine-driven doubly fed induction generatorIET Renewable Power Generation, 2010
- Design considerations for an inverter output filter to mitigate the effects of long motor leads in ASD applicationsIEEE Transactions on Industry Applications, 1997
- Filtering techniques to minimize the effect of long motor leads on PWM inverter-fed AC motor drive systemsIEEE Transactions on Industry Applications, 1996