Abstract
Traditional methods for producing Cu–Fe foils for electromagnetic interference (EMI) shielding impose limitations on both the foil thickness and the achievable iron content. In this regard, the present study explores the feasibility of fabricating such foils by electron beam physical vapour deposition (EB-PVD) of the constituent elements.Thin Cu–Fe foils with an iron content of up to 30 wt.% and a thickness of approximately 30 μm were produced by EB-PVD, and their microstructure, microhardness, and shielding effectiveness were investigated in the low-frequency (1–90 kHz) and microwave (1.6–30 GHz) ranges.It is shown that co-deposition of Cu and Fe vapour phases at substrate temperatures of 650–740 °C results in the formation of a heterogeneous lamellar microstructure, the characteristics of which are governed by composition, substrate temperature, and deposition rate. Increasing the iron content to 30 wt.% results in a significant increase in microhardness without a substantial reduction in plasticity.In the low-frequency range (1–90 kHz), the foils exhibit stable shielding effectiveness of -5.7 to -6.6 dB, whereas in the microwave range (1.6–30 GHz), values up to -44 dB are achieved, matching or exceeding those of commercial counterparts. It is demonstrated that the shielding effectiveness in the microwave range increases with increasing interfacial area density.The results indicate that the EB-PVD method enables the fabrication of thin Cu–Fe foils over a wide composition range with controllable microstructure, providing a synergistic combination of high shielding effectiveness and enhanced mechanical properties.