Vladyslav A. Moiseienko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Vladyslav A. Moiseienko has a total of 53 co-authors. Here are the top co-authors by number of shared publications:
- Liudmyla M. Grishchenko
Chuiko Institute of Surface Chemistry, National Academy of Sciences of Ukraine
17 shared publications - Igor P. Matushko
Faculty of Chemistry, Taras Shevchenko National University of Kyiv
15 shared publications - Vladyslav V. Lisnyak
Chuiko Institute of Surface Chemistry, National Academy of Sciences of Ukraine
14 shared publications - Olga Yu. Boldyrieva
Faculty of Chemistry, Taras Shevchenko National University of Kyiv
13 shared publications - Dmytro O. Zhytnyk
Faculty of Radiophysics, Electronics and Computer Systems, Taras Shevchenko National University of Kyiv
11 shared publications - Vitaliy E. Diyuk
Institute of Engineering Thermophysics, National Academy of Sciences of Ukraine
11 shared publications
Latest Publications
- 5 October 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- p. 1-23
Microwave properties of PVC-based composite films with yttrium iron garnet and carbon fillers
1. The intensive growth and large-scale implementation of contemporary telecommunication technologies have resulted in a substantial rise in electromagnetic (EM) radiation levels, which is increasi...
- 5 October 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- p. 1-23
Microwave properties of PVC-based composite films with yttrium iron garnet and carbon fillers
1. The intensive growth and large-scale implementation of contemporary telecommunication technologies have resulted in a substantial rise in electromagnetic (EM) radiation levels, which is increasi...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2211-2241
Effect of filler dispersion on microwave properties of carbon fiber–polyurethane composites in the X-band
1. The continuous expansion of electronic and communication technologies has led to a rapid increase in the density and diversity of electromagnetic sources in everyday environments [1,2]. As a con...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2211-2241
Effect of filler dispersion on microwave properties of carbon fiber–polyurethane composites in the X-band
1. The continuous expansion of electronic and communication technologies has led to a rapid increase in the density and diversity of electromagnetic sources in everyday environments [1,2]. As a con...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2184-2210
Optimizing microwave properties of activated carbon fiber–polyurethane composite planar structures
1. The continuous development of electronic and communication technologies has brought significant convenience to modern life; however, it has also led to a rapid increase in electromagnetic (EM) p...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2184-2210
Optimizing microwave properties of activated carbon fiber–polyurethane composite planar structures
1. The continuous development of electronic and communication technologies has brought significant convenience to modern life; however, it has also led to a rapid increase in electromagnetic (EM) p...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2155-2183
Ka-band microwave response of PVC-based thin-film composites filled with multi-walled carbon nanotubes
1. The rapid development of electronics and telecommunication technologies has led to a significant increase in the level of electromagnetic radiation (EMR) in the environment, especially in the fr...
- 13 August 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 2155-2183
Ka-band microwave response of PVC-based thin-film composites filled with multi-walled carbon nanotubes
1. The rapid development of electronics and telecommunication technologies has led to a significant increase in the level of electromagnetic radiation (EMR) in the environment, especially in the fr...
- 3 July 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 1-22
Microwave properties of composites based on thermoplastic polyurethane and activated carbon
- 3 July 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (12) , 1-22
Microwave properties of composites based on thermoplastic polyurethane and activated carbon
- Open Access
- 13 May 2026
- Published by Elsevier in SSRN Electronic Journal
Shielding effectiveness of thin Cu–Fe foils with a compositional microstructure produced by EB-PVD
Traditional methods for producing Cu–Fe foils for electromagnetic interference (EMI) shielding impose limitations on both the foil thickness and the achievable iron content. In this regard, the present study explores the feasibility of fabricating such foils by electron beam physical vapour deposition (EB-PVD) of the constituent elements.Thin Cu–Fe foils with an iron content of up to 30 wt.% and a thickness of approximately 30 μm were produced by EB-PVD, and their microstructure, microhardness, and shielding effectiveness were investigated in the low-frequency (1–90 kHz) and microwave (1.6–30 GHz) ranges.It is shown that co-deposition of Cu and Fe vapour phases at substrate temperatures of 650–740 °C results in the formation of a heterogeneous lamellar microstructure, the characteristics of which are governed by composition, substrate temperature, and deposition rate. Increasing the iron content to 30 wt.% results in a significant increase in microhardness without a substantial reduction in plasticity.In the low-frequency range (1–90 kHz), the foils exhibit stable shielding effectiveness of -5.7 to -6.6 dB, whereas in the microwave range (1.6–30 GHz), values up to -44 dB are achieved, matching or exceeding those of commercial counterparts. It is demonstrated that the shielding effectiveness in the microwave range increases with increasing interfacial area density.The results indicate that the EB-PVD method enables the fabrication of thin Cu–Fe foils over a wide composition range with controllable microstructure, providing a synergistic combination of high shielding effectiveness and enhanced mechanical properties.
- 13 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessShielding effectiveness of thin Cu–Fe foils with a compositional microstructure produced by EB-PVD
Traditional methods for producing Cu–Fe foils for electromagnetic interference (EMI) shielding impose limitations on both the foil thickness and the achievable iron content. In this regard, the present study explores the feasibility of fabricating such foils by electron beam physical vapour deposition (EB-PVD) of the constituent elements.Thin Cu–Fe foils with an iron content of up to 30 wt.% and a thickness of approximately 30 μm were produced by EB-PVD, and their microstructure, microhardness, and shielding effectiveness were investigated in the low-frequency (1–90 kHz) and microwave (1.6–30 GHz) ranges.It is shown that co-deposition of Cu and Fe vapour phases at substrate temperatures of 650–740 °C results in the formation of a heterogeneous lamellar microstructure, the characteristics of which are governed by composition, substrate temperature, and deposition rate. Increasing the iron content to 30 wt.% results in a significant increase in microhardness without a substantial reduction in plasticity.In the low-frequency range (1–90 kHz), the foils exhibit stable shielding effectiveness of -5.7 to -6.6 dB, whereas in the microwave range (1.6–30 GHz), values up to -44 dB are achieved, matching or exceeding those of commercial counterparts. It is demonstrated that the shielding effectiveness in the microwave range increases with increasing interfacial area density.The results indicate that the EB-PVD method enables the fabrication of thin Cu–Fe foils over a wide composition range with controllable microstructure, providing a synergistic combination of high shielding effectiveness and enhanced mechanical properties.
- 8 May 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (9) , 1-20
Poly(vinyl chloride)-based carbon nanoparticle composites: preparation and microwave properties
1. The rapid expansion of wireless communication technologies has significantly increased the density of electromagnetic radiation in modern environments; however, it has also increased human expos...
- 8 May 2026
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 770 (9) , 1-20
Poly(vinyl chloride)-based carbon nanoparticle composites: preparation and microwave properties
1. The rapid expansion of wireless communication technologies has significantly increased the density of electromagnetic radiation in modern environments; however, it has also increased human expos...
- 9 August 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1372-1395
Effect of amination after bromination on the ultra-high frequency microwave properties of polyacrylonitrile (PAN) precursor-based carbon fibers
- 9 August 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1372-1395
Effect of amination after bromination on the ultra-high frequency microwave properties of polyacrylonitrile (PAN) precursor-based carbon fibers
- 3 August 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1572-1585
Polyvinyl chloride/yttrium iron garnet thin-film composites: obtaining and microwave properties
- 3 August 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1572-1585
Polyvinyl chloride/yttrium iron garnet thin-film composites: obtaining and microwave properties
- 2 July 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1396-1414
Microwave properties of polyvinyl chloride/oxidized activated carbon thin-film composites in the Ka-band
- 2 July 2025
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 769 (15-18) , 1396-1414
Microwave properties of polyvinyl chloride/oxidized activated carbon thin-film composites in the Ka-band