A phenomenological modelling framework for particle emission simulation in a direct-injection gasoline engine
Open Access
- 3 January 2020
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 22 (4) , 1166-1179
Abstract
A phenomenological modelling framework is presented that allows the simulation of the engine-out particle emissions of direct-injection gasoline engines based on physical principles. It is applicable both at steady-state operating conditions and in transient driving cycles. Within the modelling framework, a multi-zone model with gas-phase reaction kinetics is coupled with a stochastic reactor model considering the soot formation dynamics. Both model parts are fed with inputs from an accompanying engine process simulation. Particle emissions from injector deposits and inhomgeneous gaseous mixture preparation are taken into account. Pyrolysis reactions are considered in a zone with remaining fuel film at the injector, whereas in gas-phase zones that arise from inhomogeneous mixture preparation, the reaction of the air–fuel mixture is calculated under sub-stoichiometric conditions. The setup of those mixture-induced zones is generated by an existing homogenisation sub-model. The modelling framework is evaluated by test bench measurements of the engine operating map, a variation of engine actuator settings and transient driving profiles. Hereby, an accuracy of less than 20% deviation for particle number and mass is achieved.Keywords
This publication has 39 references indexed in Scilit:
- Soot predictions in premixed and non-premixed laminar flames using a sectional approach for PAHs and sootCombustion and Flame, 2012
- Modelling soot formation in a DISI engineProceedings of the Combustion Institute, 2011
- Hybrid Method of Moments for modeling soot formation and growthCombustion and Flame, 2009
- Chemical mechanism for high temperature combustion of engine relevant fuels with emphasis on soot precursorsCombustion and Flame, 2009
- Coupling a stochastic soot population balance to gas-phase chemistry using operator splittingCombustion and Flame, 2007
- Extending stochastic soot simulation to higher pressuresCombustion and Flame, 2006
- A stochastic approach to calculate the particle size distribution function of soot particles in laminar premixed flamesCombustion and Flame, 2003
- Models of soot formation and oxidationProgress in Energy and Combustion Science, 1997
- A correlation for soot concentration in diesel exhaust based on fuel-air mixing parametersFuel, 1992
- A simple nucleation/depletion model for the spherule size of particulate carbonCombustion and Flame, 1982