Monitoring toppling failures using wireless inertial measurement unit sensors
Open Access
- 1 June 2022
- journal article
- research article
- Published by Emerald Publishing in Geotechnical Research
- Vol. 9 (2) , 83-94
Abstract
A topple is a common rock slope failure – and usually the cause of a rockfall – that depends on the slope and rock geometries. This paper presents a laboratory simulation and field generation of a single-column rock topple failure. Innovative inertial measurement unit (IMU) sensors were used to collect three-dimensional acceleration and angular velocity data during four laboratory experiments to understand and characterise general toppling behaviours. A topple is identified by the gradual change in at least two gravity accelerations, the continuous increase in at least one of the angular velocities and a significant change in the linear acceleration in the direction of toppling. A field experiment showed similar sensor data patterns to those observed from the laboratory experiments. An isolated-block stability analysis of a single-column topple provides the basis for incorporating the IMU sensors into the development of future monitoring and early warning systems.Keywords
This publication has 16 references indexed in Scilit:
- On the monitoring and early-warning of brittle slope failures in hard rock masses: Examples from an open-pit mineEngineering Geology, 2017
- Gravity-Based Characterization of Three-Axis Accelerometers in Terms of Intrinsic Accelerometer ParametersJournal of Research of the National Institute of Standards and Technology, 2017
- Managing rockfall risk through baseline monitoring of precursors using a terrestrial laser scannerCanadian Geotechnical Journal, 2017
- The Use of Remote Sensing Techniques for Monitoring and Characterization of Slope InstabilityProcedia Engineering, 2017
- Real time monitoring & alert system for landslide2016
- Investigation of seepage effect on river dike’s stability under steady state and transient conditionsPollack Periodica, 2016
- Design and Testing of a Debris Flow ‘Smart Rock’Geotechnical Testing Journal, 2014
- Analysis of geo-structural defects in flexural toppling failureInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Analysis of a complex toppling-circular slope failureEngineering Geology, 2010
- Integrated back and forward analysis of rock slope stability and rockslide runout at Afternoon Creek, WashingtonCanadian Geotechnical Journal, 2009