On the Properties and Long-Term Stability of Infiltrated Lanthanum Cobalt Nickelates (LCN) in Solid Oxide Fuel Cell Cathodes
- 9 May 2017
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (7) , F748-F758
Abstract
Infiltration as a fabrication method for solid oxide fuel cells (SOFC) electrodes is offering significant improvements in cell performance at reduced materials and fabrication costs, especially when combined with co-sintering. However, important questions regarding the long-term performance and microstructural stability remain unanswered. Here, we present the results of a three-year project, where large footprint anode-supported SOFCs with a co-sintered cathode backbone and infiltrated La0.95Co0.4Ni0.6O3 (LCN) cathodes were developed and thoroughly characterized. The initial long-term performance and stability of this new cell type was investigated for 1500+ hours, coupled with STEM-EDS investigation of the microstructural changes in the infiltrated electrodes. Additionally, electrodes were further aged at elevated temperatures (750 - 900°C) for periods reaching up to 5000 hours, while following changes in the electrode properties using SEM, BET area, and in-plane conductivity measurements. Finally, the mechanical properties of co-sintered cathode backbone cells were determined in four-point bending tests carried out both at room temperature and at 800°C in air. Based on these results, degradation mechanisms were identified and recommendation for safe operation conditions in real life application could be formulated.Keywords
This publication has 63 references indexed in Scilit:
- Development of lanthanum nickelate as a cathode for use in intermediate temperature solid oxide fuel cellsSolid State Ionics, 2011
- Effect of the Ionic Conductivity of the Electrolyte in Composite SOFC CathodesJournal of the Electrochemical Society, 2011
- Dopants to enhance SOFC cathodes based on Sr-doped LaFeO3 and LaMnO3Journal of Power Sources, 2010
- Thermodynamic analysis of solid oxide fuel cells operated with methanol and ethanol under direct utilization, steam reforming, dry reforming or partial oxidation conditionsJournal of Power Sources, 2009
- Evaluation and Modeling of the Cell Resistance in Anode-Supported Solid Oxide Fuel CellsJournal of the Electrochemical Society, 2008
- The Stability of LSF-YSZ Electrodes Prepared by InfiltrationJournal of the Electrochemical Society, 2007
- Break Down of Losses in Thin Electrolyte SOFCsFuel Cells, 2006
- Particle size distributions in heterogeneous catalysts: What do they tell us about the sintering mechanism?Catalysis Today, 2006
- An Examination of LSM-LSCo Mixtures for Use in SOFC CathodesJournal of the Electrochemical Society, 2006
- Low‐Temperature Fabrication of Oxide Composites for Solid‐Oxide Fuel CellsJournal of the American Ceramic Society, 2004