Porous Lead Iodide Layer Promotes Organic Amine Salt Diffusion to Achieve High Performance p‐i‐n Flexible Perovskite Solar Cells
Authors:
- 8 August 2023
- journal article
- research article
- Published by Wiley in Advanced Energy Materials
- Vol. 13 (36)
Abstract
Flexible perovskite solar cells (FPSCs) are attracting widespread research and attention for their benefits as the next‐generation wearable electronic products. However, there are still many challenges in the quest to achieve dense, pinhole‐free, high crystal quality, low defect, and stable perovskite films, which limit further improvement in the efficiency and stability of FPSCs. Herein, a novel technique for the incorporation of quaternary ammonium halide (QAH) additives to prepare fluffy porous lead iodide layers by using a two‐step sequential deposition method, is reported. Benefiting from the good diffusion of organic amine salts on porous PbI2 layers, flat and dense perovskite films are produced with large particle sizes, few defects, and high crystal quality. Finally, the champion rigid and flexible p‐i‐n PSCs with the 2‐(acetyloxy)‐N,N,N‐trimethylethanium chloride (AtaCl) additive achieves exciting power conversion efficiencies (PCE) of 23.40% and 21.10%, respectively. The device with the AtaCl additive retains over 90% of its original PCE under ambient conditions (40 ± 5% relative humidity (RH)) over 1000 h of aging without encapsulation. In addition, the flexible device with the AtaCl additive shows excellent stability under mechanical bending conditions, retaining ≈85% of its original PCE after 10 000 cycles (bending radius = 5 mm).Keywords
Funding Information
- FP7 International Cooperation
This publication has 73 references indexed in Scilit:
- Instability in CH3NH3PbI3 perovskite solar cells due to elemental migration and chemical composition changesScientific Reports, 2017
- Planar‐Structure Perovskite Solar Cells with Efficiency beyond 21%Advanced Materials, 2017
- Aluminum‐Doped Cesium Lead Bromide Perovskite Nanocrystals with Stable Blue Photoluminescence Used for Display BacklightAdvanced Science, 2017
- Defect passivation in hybrid perovskite solar cells using quaternary ammonium halide anions and cationsNature Energy, 2017
- Strongly emissive perovskite nanocrystal inks for high-voltage solar cellsNature Energy, 2016
- Photoinduced degradation of methylammonium lead triiodide perovskite semiconductorsJournal of Materials Chemistry A, 2016
- Polymer-templated nucleation and crystal growth of perovskite films for solar cells with efficiency greater than 21%Nature Energy, 2016
- Functionalization of perovskite thin films with moisture-tolerant moleculesNature Energy, 2016
- Is Excess PbI2 Beneficial for Perovskite Solar Cell Performance?Advanced Energy Materials, 2016
- Organometal Halide Perovskites as Visible-Light Sensitizers for Photovoltaic CellsJournal of the American Chemical Society, 2009