Printing Path Geometry Controls Stress Concentration at Interlayer Notches in 3D-Printed Concrete: DIC Evidence and Mechanistic Interpretation
Preprint
- 20 April 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Extrusion-based 3D concrete printing (3DCP) generates periodic interlayer notches whose geometry depends on the nozzle cross-section, rheology, and deposition conditions. These notches act as stress concentrators — yet no scalar stress concentration factors (SCF) have been reported for interlayer interfaces in 3DCP under compression. Nineteen five-layer specimens — printed with a circular nozzle (O) and a trapezoidal nozzle at nominal (P) and excessive (T) extrusion rates — were tested under uniaxial compression with 3D DIC. The measured SCF ranking (O > T > P) is consistent with the geometric severity ranking (O ≥ T > P), confirming that printing path geometry controls stressconcentration. SCF was evaluated from DIC-measured surface strains, which equal stress ratios in the linear-elastic regime. Measured SCF values (1.3–1.8) are 2–3 times lower than those obtainedin cast specimens with geometrically similar notch profiles (3.4–4.7), which is jointly explained by fracture process zone (FPZ) development, Theory of Critical Distances (TCD), and DIC virtual strain gauge (VSG) averaging. SCF decreased with load, consistent with progressive FPZ growth. Scatter was highest for circular-nozzle specimens, reflecting stochastic notch geometry. All specimens failed by matrix splitting or shear banding, not delamination, confirming adequate interlayer bond quality.Keywords
This publication has 30 references indexed in Scilit:
- On the origins of anisotropy of extrusion-based 3D printed concrete: The roles of filament skin and agglomerationCement and Concrete Research, 2025
- Fracture process zone development and length assessment under the mixed-mode I/II load analysed by digital image correlation techniqueCement and Concrete Research, 2023
- On the Importance of Direct-Levelling for Constitutive Material Model Calibration using Digital Image Correlation and Finite Element Model UpdatingExperimental Mechanics, 2022
- Evaluation of Processing Parameters in High-Speed Digital Image Correlation for Strain Measurement in Rock TestingRock Mechanics and Rock Engineering, 2022
- Combination of acoustic emission and digital image correlation monitoring for wedge splitting tests on large concrete specimensConstruction and Building Materials, 2022
- Evaluating the effects of porosity on the mechanical properties of extrusion-based 3D printed concreteCement and Concrete Research, 2022
- Lengthscale effects in optical strain measurement for fracture characterization in simple shearInternational Journal of Fracture, 2021
- Automated crack detection and measurement based on digital image correlationConstruction and Building Materials, 2020
- Influence of process parameters on the interlayer bond strength of concrete elements additive manufactured by Shotcrete 3D Printing (SC3DP)Cement and Concrete Research, 2020
- Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elementsCement and Concrete Research, 1976