Machining and optimization of Zircaloy-2 using different tool electrodes
- 14 April 2021
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 36 (13) , 1513-1523
Abstract
To explore machining parameters for tool wear rate, surface roughness, and material removal rate, Zircaloy-2 was machined with EDM using Cu, CuW and graphite tool. Taguchi L18 Design was used to perform experiments with five independent process parameters (tool material, on-time, off-time, polarity, and current). Response parameters were evaluated and optimized using gray relation analysis and entropy-integrated-gray-VIKOR methods. FESEM was used to observe tool material and oxide layer deposition on machined surface. Maximum material removal rate (1.53 × 10−3 mm3/min) was obtained when the graphite tool with negative tool polarity was used. A confirmation test performed on the optimal factor level process parameters gives an error of 1.9%, 6.4%, and 9.8% for TWR, SR, and MRR respectively.Keywords
This publication has 31 references indexed in Scilit:
- Influence of discharge energy on machining characteristics in EDMJournal of Mechanical Science and Technology, 2012
- The use of SiC powder in water as dielectric for micro-slit EDM machiningJournal of Materials Processing Technology, 2008
- The behavior of graphite and copper electrodes on the finish die-sinking electrical discharge machining (EDM) of AISI P20 tool steelJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2007
- Compromise solution by MCDM methods: A comparative analysis of VIKOR and TOPSISEuropean Journal of Operational Research, 2004
- Machining of a Zr–Ti–Al–Cu–Ni metallic glassScripta Materialia, 2004
- State of the art electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2003
- Inter-company comparison using modified TOPSIS with objective weightsComputers & Operations Research, 2000
- Hydrogen ingress through EDM surfaces of Zr–2.5Nb pressure-tube materialJournal of Nuclear Materials, 1998
- PROCESSING ASPECTS OF SHAPING ADVANCED MATERIALS BY ELECTRICAL DISCHARGE MACHININGAdvanced Materials and Manufacturing Processes, 1988
- Control problems of grey systemsSystems & Control Letters, 1982