Fractal Analysis on Machined Surface Morphologies of Soft-Brittle KDP Crystals Processed by Micro Ball-End Milling
Open Access
Abstract
The micro-defects on KH2PO4 (KDP) optic surfaces are mainly repaired by the micro-milling technique, while it is very easy to introduce brittle cracks on repaired surfaces, as KDP is soft and brittle. To estimate machined surface morphologies, the conventional method is surface roughness, but it fails to distinguish ductile-regime machining from brittle-regime machining directly. To achieve this objective, it is of great significance to explore new evaluation methods to further characterize machined surface morphologies. In this study, the fractal dimension (FD) was introduced to characterize the surface morphologies of soft-brittle KDP crystals machined by micro bell-end milling. The 3D and 2D fractal dimensions of the machined surfaces and their typical cross-sectional contours have been calculated, respectively, based on Box-counting methods, and were further discussed comprehensively by combining the analysis of surface quality and textures. The 3D FD is identified to have a negative correlation with surface roughness (Sa and Sq), meaning the worse the surface quality the smaller the FD. The circumferential 2D FD could quantitively characterize the anisotropy of micro-milled surfaces, which could not be analyzed by surface roughness. Normally, there is obvious symmetry of 2D FD and anisotropy on the micro ball-end milled surfaces generated by ductile-regime machining. However, once the 2D FD is distributed asymmetrically and the anisotropy becomes weaker, the assessed surface contours would be occupied by brittle cracks and fractures, and corresponding machining processes will be in a brittle regime. This fractal analysis would facilitate the accurate and efficient evaluation of the repaired KDP optics by micro-milling.Keywords
Funding Information
- National Natural Science Foundation of China (52235010, 52175389, 52293403, YQ2021E021)
- Natural Science Foundation of Heilongjiang Province (52235010, 52175389, 52293403, YQ2021E021)
- University of Strathclyde (52235010, 52175389, 52293403, YQ2021E021)
- University of Nottingham (52235010, 52175389, 52293403, YQ2021E021)
This publication has 50 references indexed in Scilit:
- Cutting surface quality analysis in micro ball end-milling of KDP crystal considering size effect and minimum undeformed chip thicknessPrecision Engineering, 2017
- The influence of processing parameters on surface characteristics in micro-milling thin-walled slot on ElgiloyThe International Journal of Advanced Manufacturing Technology, 2017
- Influence of process parameters on surface topography in ultrasonic vibration- assisted end grinding of SiCp/Al compositesThe International Journal of Advanced Manufacturing Technology, 2017
- The Limitations of Using “Ra” to Describe Surface RoughnessJournal of Turbomachinery, 2016
- Uncertainty in measurement of surface topographySurface Topography: Metrology and Properties, 2015
- Fractal characterization of the silicon surfaces produced by ion beam irradiation of varying fluencesApplied Surface Science, 2015
- Practical estimation of measurement noise and flatness deviation on focus variation microscopesCIRP Annals, 2014
- Study on the optical performance and characterization method of texture on KH2PO4 surface processed by single point diamond turningApplied Surface Science, 2013
- Analysis of 3D microtopography in machined KDP crystal surfaces based on fractal and wavelet methodsInternational Journal of Machine Tools and Manufacture, 2008
- Fractal character of fracture surfaces of metalsNature, 1984