New spectrally selective coatings for CSP linear receivers operating in air at high temperature
Authors:
Open Access
- 3 May 2023
- journal article
- research article
- Published by Wiley in Applied Research
- Vol. 3 (2)
Abstract
An attractive candidate to reduce dependence on fossil fuels and replace them by renewable sources is represented by concentrated solar power (CSP) technology, whose wide deployment is still hindered by its high investment costs. In CSP linear collector plants, a key component with high technological content may be identified in receiver tubes, that are traversed by heat transfer fluid and located on focal line on which solar radiation is concentrated by mirrors. The proposed work aims at developing spectrally selective coatings for receiver tubes able to overcome state‐of‐the‐art technological limitation in terms of both vacuum encapsulation and maximum operative temperature, currently limited at 550°C for molten salts CSP plants. To this aim, a multilayer structure was designed and developed for coating a receiver tube to be employed in open‐air environment at temperature of 600°C. The multilayer coating is based on tungsten chromium titanium infrared reflector and includes a solar absorber layer developed with two alternative methods of reactive sputtering and thermal oxidation respectively, finally covered by antireflective and barrier bi‐layer of aluminum oxide and silica. Thermal stability was demonstrated of the new developed coatings, since only small variations were measured of the optical parameters after more than 2000 h of aging in open air conditions at temperature of 600°C (on average less than 5%), with final measured solar absorptance αs of 73% and 87% and thermal emissivity εth at 600°C of 18% and 27% for aged multilayer structures including the absorber layer obtained through thermal oxidation and sputtering process, respectively. These results pave the way for further improvement in terms of both optical performance and operative temperature increase, allowing to enhance efficiency and lower costs, thus contributing to ease to deployment of CSP technology.Keywords
This publication has 23 references indexed in Scilit:
- Maximizing concentrated solar power (CSP) plant overall efficiencies by using spectral selective absorbers at optimal operation temperaturesSolar Energy, 2015
- Solvent additives for tuning the photovoltaic properties of polymer–fullerene solar cellsSolar Energy Materials and Solar Cells, 2011
- Oxidation behaviour of silicon-free tungsten alloys for use as the first wall materialPhysica Scripta, 2011
- Effects of aging and drying conditions on the structural and textural properties of silica gelsMicroporous and Mesoporous Materials, 2007
- Self passivating W-based alloys as plasma facing material for nuclear fusionPhysica Scripta, 2007
- Materials chemistry for low-k materialsMaterials Today, 2006
- Reactive magnetron sputtering of thin films: present status and trendsThin Solid Films, 2005
- Recent aspects concerning DC reactive magnetron sputtering of thin films: a reviewSurface and Coatings Technology, 2000
- Electrochemical and XPS studies on the passivation behavior of sputter-deposited W-Cr Alloys in 12 M HCl solutionCorrosion Science, 1998
- The deposition of hard crystalline Al2O3 layers by means of bipolar pulsed magnetron sputteringSurface and Coatings Technology, 1996