Effect on Top-Coal Mass Failure under Load–Unload Induced by Shield Support
Open Access
Abstract
Prior to being released, the top coal of a fully mechanized caving face typically experiences the effects of mining-induced pressure and disturbances from the hydraulic support’s canopy. To investigate the promoting effect of canopy disturbances in the support-controlled area on the damage of top coal during fully mechanized top-coal caving mining, block instability theory and discrete block numerical simulation methods were employed. The instability modes during the initial support and cyclic disturbance stages were analyzed. The fracture evolution and displacement distribution curves were studied for coal bodies with strengths of 3.1 MPa, 15.0 MPa, and 29.5 MPa under the mining influence and support strengths of 0.5 MPa, 1.0 MPa, and 1.5 MPa during the initial support and cyclic disturbance processes. The results showed that during the initial support stage, the instability of the block-structured coal body exhibited four modes as follows: inter-block breakage, inter-block delamination, intra-block fracture expansion, and inter-block sliding. During the cyclic disturbance stage, the coal body instability showed three modes as follows: inter-block sliding, intra-block fracture expansion, and inter-block rotation. The disturbance from the support had little impact on the fragmentation of both low-strength and high-strength coal bodies. However, small support forces combined with multiple cycles of disturbance had an enhancing effect on the instability of medium-strength block-structured top coal.Keywords
Funding Information
- National Natural Science Foundation of China (52374110, 242102320337, K2022QN008)
- key scientific and technological projects of Henan Province (52374110, 242102320337, K2022QN008)
- Basic Research Fund of Zhongyuan University of Technology (52374110, 242102320337, K2022QN008)
This publication has 36 references indexed in Scilit:
- Modeling and coupling analysis of enhanced coalbed methane recovery by gas injectionInternational Journal for Numerical and Analytical Methods in Geomechanics, 2024
- Research on the bearing characteristics of brackets in thick hard roof mining sites and the effect of blasting on roof controlGeomechanics and Geophysics for Geo-Energy and Geo-Resources, 2024
- Determination of working resistance of support parameter variation of large mining height support: the case of Caojiatan coal mineGeomechanics and Geophysics for Geo-Energy and Geo-Resources, 2024
- DEM fluid–solid coupling method for progressive failure simulation of roadways in a fault structure area with water-rich roofsGeomechanics and Geophysics for Geo-Energy and Geo-Resources, 2022
- Reasonable stopping method and retracement channel support at fully mechanized top coal caving working face of 15 m extra‐thick coal seam: A case studyEnergy Science & Engineering, 2022
- Motion Mechanisms for Top Coal and Gangue Blocks in Longwall Top Coal Caving (LTCC) with an Extra-Thick SeamRock Mechanics and Rock Engineering, 2022
- Experimental Study of Mechanical Behaviors and Failure Characteristics of Coal Under True Triaxial Cyclic Loading and Unloading and Stress RotationNatural Resources Research, 2022
- Drawing mechanisms for top coal in longwall top coal caving (LTCC): A review of two decades of literatureInternational Journal of Coal Science & Technology, 2021
- Study on the failure mechanism and stability control measures in a large-cutting-height coal mining face with a deep-buried seamBulletin of Engineering Geology and the Environment, 2019
- Analysis on Roadside Support Method with Constant Resistance Yielding-Supporting Along the Goaf Under Hard RocksGeotechnical and Geological Engineering, 2016