Spectroscopy of Single Vacuum Arc Cathode Spots With Improved Sensitivity
- 16 April 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 41 (8) , 1904-1910
Abstract
Recently, we reported on the optical emission of vacuum arc discharges with a single cathode spot. The discharges were initiated by rectangular voltage pulses of 100-ns length produced by a cable generator. In combination with the application of a liquid Ga-In alloy cathode and ultrahigh vacuum conditions, a high reproducibility was obtained. An improvement of the sensitivity and the signal-to-noise ratio was achieved by the replacement of the streak camera by an intensified charge-coupled device camera. Thus, the accumulation of calibrated spectra with high temporal, spatial, and wavelength resolution was possible. Distinct differences in the temporal development of the atomic and ionic line intensities were found depending on the spatial position, that is, comparing the spot core and the spot surrounding.Keywords
This publication has 8 references indexed in Scilit:
- Time- and Spectrum-Resolved Study of a Single Cathode Spot in VacuumIEEE Transactions on Plasma Science, 2011
- Spectroscopic Study of a Single Vacuum-Arc Cathode SpotIEEE Transactions on Plasma Science, 2009
- Explosive Electron Emission From Liquid-Metal CathodesIEEE Transactions on Plasma Science, 2009
- Spectral Data for Gallium: Ga I through Ga XXXIJournal of Physical and Chemical Reference Data, 2007
- Plasma parameters of an arc cathode spot at the low-current vacuum dischargeIEEE Transactions on Plasma Science, 2003
- Brightness distribution and current density of vacuum arc cathode spotsJournal of Physics D: Applied Physics, 1992
- Pulsed Electrical Discharge in Vacuum1989
- Improved Stark Profile Calculations for the Hydrogen Lines , , , andPhysical Review B, 1968