Primary and secondary gas penetration during gas‐assisted injection molding. Part I: Formulation and modeling
Authors:
- 1 May 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (5) , 983-991
Abstract
A theoretical study has been carried out on the transient gas‐liquid interface development and gas penetration behavior during the cavity filling and gas packing stage in the gas‐assisted injection molding (GAIM) of a tube cavity. A mathematical formulation describing the evolution of the gas/melt interface and the distribution of the residual wall thickness of skin melt along with the advancement of gas/melt front is presented. The physical model is put forward on the basis of Hele‐Shaw approximation and interface kinematics and dynamics. Numerical simulation is implemented on a fixed mesh covering the entire cavity. The model and simulation can deal with both primary and secondary gas penetrations. The predicted and measuredresults are compared in Part II of this study to validate the theoretical model. Polym. Eng. Sci. 44:983–991, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 29 references indexed in Scilit:
- Interface evolution and penetration behavior during two‐component transfer molding. Part I: Modeling and formulationPolymer Engineering & Science, 2004
- A 3‐D finite element model for gas‐assisted injection molding: Simulations and experimentsPolymer Engineering & Science, 2001
- Molding Processes2000
- Perturbation method in gas-assisted power-law fluid displacement in a circular tube and a rectangular channelChemical Engineering Journal, 1999
- Gas-assisted displacement of viscoelastic fluids: flow dynamics at the bubble frontJournal of Non-Newtonian Fluid Mechanics, 1999
- The penetration of a long bubble through a viscoelastic fluid in a tubeJournal of Non-Newtonian Fluid Mechanics, 1997
- Fingering in 2D Parallel Viscous FlowJournal de Physique II, 1997
- Polymer melt flow and gas penetration in gasassisted injection molding of a thin part with gas channel designInternational Journal of Heat and Mass Transfer, 1996
- Development and application of CAE technology for the gas‐assisted injection molding processAdvances in Polymer Technology, 1995
- A finite-element/finite-difference simulation of the injection-molding filling processJournal of Non-Newtonian Fluid Mechanics, 1980