Elaboration of Natural Hydroxyapatite Coating by Plasma Spraying
Open Access
Abstract
Metallic implants used in orthopedics, such as titanium alloys, possess excellent mechanical strength but suffer from corrosion and poor bio-integration, often necessitating revision surgeries. Bioactive coatings, particularly hydroxyapatite, can enhance implant osteoconductivity, but high-purity synthetic hydroxyapatite is costly. This study investigates the development and characterization of a low-cost, biocompatible coating using hydroxyapatite derived from an unconventional natural source dromedary bone applied onto a titanium substrate via plasma spraying. Hydroxyapatite powder was synthesized from dromedary femurs through a thermal treatment process at 1000 °C. The resulting powder was then deposited onto a sandblasted titanium dioxide substrate using an atmospheric plasma spray technique. The physicochemical, structural, and morphological properties of both the source powder and the final coating were comprehensively analyzed using Scanning Electron Microscopy, Energy Dispersive X-ray Spectroscopy, X-ray Diffraction, and Fourier-Transform Infrared Spectroscopy. Characterization of the powder confirmed the successful synthesis of pure, crystalline hydroxyapatite, with Fourier-Transform Infrared Spectroscopy analysis verifying the complete removal of organic matter. The plasma-sprayed coating exhibited good adhesion and a homogenous, lamellar microstructure typical of thermal spray processes, with an average thickness of approximately 95 μm. X-ray Diffraction analysis of the coating revealed that while hydroxyapatite remained the primary phase, partial decomposition occurred during spraying, leading to the formation of secondary phases, including tricalcium phosphate and calcium oxide. Scanning Electron Microscopy imaging showed a porous surface composed of fully and partially melted particles, a feature potentially beneficial for bone integration. The findings demonstrate that dromedary bone is a viable and low-cost precursor for producing bioactive hydroxyapatite coatings for orthopedic implants. The plasma spray method successfully creates a well-adhered, porous coating, though process-induced phase changes must be considered for biomedical applications.Keywords
This publication has 25 references indexed in Scilit:
- Antibacterial HA-coatings on bioresorbable Mg alloyJournal of Magnesium and Alloys, 2024
- Extraction of natural hydroxyapatite for biomedical applications—A reviewHeliyon, 2022
- Bone grafting materials in dentoalveolar reconstruction: A comprehensive reviewJapanese Dental Science Review, 2019
- Preparation of Hydroxyapatite from Dromedary Bone by Heat TreatmentInternational Journal of Environmental Research, 2019
- A review of hydroxyapatite-based coating techniques: Sol–gel and electrochemical depositions on biocompatible metalsJournal of the Mechanical Behavior of Biomedical Materials, 2016
- Calcium phosphate coatings on magnesium alloys for biomedical applications: A reviewActa Biomaterialia, 2012
- Synthesis, mechanical and biological characterization of ionic doped carbonated hydroxyapatite/β-tricalcium phosphate mixturesActa Biomaterialia, 2011
- Properties of hydroxyapatite produced by annealing of bovine boneCeramics International, 2007
- The mechanical properties and osteoconductivity of hydroxyapatite bone scaffolds with multi-scale porosityBiomaterials, 2007
- Natural hydroxyapatite—its behaviour during heat treatmentJournal of the European Ceramic Society, 2006