Tribological properties of water‐based nanofluids prepared by multi‐walled carbon nanotubes composites filled with sulfurised isobutylene
- 9 February 2022
- journal article
- research article
- Published by Wiley in Lubrication Science
- Vol. 34 (4) , 275-289
Abstract
Sulfurised isobutylene (T321) was filled into the cavity of multi‐walled carbon nanotubes (MWCNTs) in order to synthesise MWCNT/T321 composites. Tribological properties of water‐based nanofluids with composites as additives were systematically investigated using a four‐ball configuration. The results showed that MWCNTs were filled by T321 with a filling rate of 22.5%. The nanofluids prepared by the composites produced a significantly lower coefficient of friction and wear loss, in comparison with the lubricants containing only MWCNTs or T321. Such improvement was attributed to the fact that during sliding the T321 filled into composites was released onto the rubbing surface to generate a lubricating film, resulting in a low resistance to shear, whilst the MWCNTs served as nano‐bearings on the formed lubricating film.Keywords
Funding Information
- National Natural Science Foundation of China (51805345)
- Natural Science Foundation of Jiangsu Province (BK20170373)
This publication has 53 references indexed in Scilit:
- The efficiency of Co-based single-wall carbon nanotubes (SWNTs) as an AW/EP additive for mineral base oilsWear, 2012
- Effect of Nano-Enhanced Lubricant in Minimum Quantity Lubrication Balling MillingJournal of Tribology, 2011
- Selective Intercalation of Polymers in Carbon NanotubesLangmuir, 2007
- Friction properties of surface-fluorinated carbon nanotubesWear, 2005
- Lubricating mechanisms of sulfurized olefin on oxynitrided steel surface under boundary lubrication conditionWear, 1996
- Capillarity and Wetting of Carbon NanotubesScience, 1994
- Capillarity-induced filling of carbon nanotubesNature, 1993
- Nanocapillarity in fullerene tubulesPhysical Review Letters, 1992
- Helical microtubules of graphitic carbonNature, 1991
- Chain length effects in boundary lubricationWear, 1985