Rapid and conservative ablation and modification of enamel, dentin, and alveolar bone using a high repetition rate transverse excited atmospheric pressure CO[sub 2] laser operating at λ=9.3 μm
- 1 January 2006
- journal article
- research article
- Published by SPIE-Intl Soc Optical Eng in Journal of Biomedical Optics
- Vol. 11 (6) , 064008-064008-11
Abstract
Transverse excited atmospheric pressure (TEA) lasers tuned to the strong mineral absorption of hydroxyapatite near are well suited for the efficient ablation of dental hard tissues if the laser pulse is stretched to greater than to avoid plasma shielding phenomena. Such lasers are capable of operating at high repetition rates for the rapid removal of dental hard tissues. The purpose of this study was to test the hypothesis that stretched TEA laser pulses can produce lateral incisions in enamel, dentin, and alveolar bone for dental restorations and implants at repetition rates as high as without peripheral thermal damage. The single pulse ablation rates through enamel, dentin, and bone were determined for incident fluence ranging from for laser pulses from in duration. Lateral incisions were produced in hard tissue samples using a computer-controlled scanning stage and water spray, and the crater morphology and chemical composition were measured using optical microscopy and high-resolution synchrotron radiation infrared spectromicroscopy. The residual energy remaining in tooth samples was measured to be 30 to 40% for enamel and 20 to 30% for dentin without water cooling, under optimum irradiation intensities, significantly lower than for longer laser pulses. The transmission through length 300-, 500-, 750-, and silica hollow waveguides was measured and 80% transmission was achieved with per pulse. These results suggest that high repetition rate TEA laser systems operating at with pulse durations of are well suited for dental applications.
Keywords
This publication has 47 references indexed in Scilit:
- Peripheral thermal and mechanical damage to dentin with microsecond and sub‐microsecond 9.6 μm, 2.79 μm, and 0.355 μm laser pulsesLasers in Surgery and Medicine, 2004
- Thermal and chemical modification of dentin by 9–11‐μm CO2 laser pulses of 5–100‐μs durationLasers in Surgery and Medicine, 2002
- Dental hard tissue modification and removal using sealed transverse excited atmospheric-pressure lasers operating at λ=9.6 and 10.6 μmJournal of Biomedical Optics, 2001
- Influence of wavelength and pulse duration on peripheral thermal and mechanical damage to dentin and alveolar bone during IR laser ablation2000
- Optical properties of dental enamel in the mid-IR determined by pulsed photothermal radiometryIEEE Journal of Selected Topics in Quantum Electronics, 1999
- Novel CO2 laser system for hard tissue ablation1994
- Hard-tissue ablation with pulsed CO 2 lasers1993
- Bone-ablation mechanism using CO2 lasers of different pulse duration and wavelengthApplied Physics B, 1993
- Time constants in thermal laser medicineLasers in Surgery and Medicine, 1989
- Laser Effects On Dental Hard TissuesAdvances in Dental Research, 1987