Additive manufacturing of short fiber oxide ceramic matrix composite: Process analysis and material properties
Open Access
- 1 July 2024
- journal article
- research article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 21 (6) , 3863-3875
Abstract
This work investigates the material extrusion‐based additive manufacturing (AM) process chain of a pure alumina‐based oxide ceramic matrix composite, starting from material selection, large‐scale compounding to pellets, the AM process itself, debinding and sintering as well as microstructural and mechanical characterization. The compounded pellets have a volume share of 50% binder (polyvinyl butyral [PVB], polyethylene glycol [PEG], and stearic acid) and 50% alumina (Al 2 O 3 , alumina powder, and Nextel 610 alumina fibers) with an aimed fiber volume share of 40% after sintering. The material is compounded on an industrial scale with approximately 10 kg/h and the material extrusion‐based AM process reaches speeds of up to 1000 mm/s. A variation of the feed rate leads to a significant increase in surface roughness and an increase in mass of 30%, in thickness of 12% and in width of 25%. The flexural behavior in the four‐point‐bending test can be described by a fast first peak and reaching higher flexural strength after the first crack subsequent with averages of 23.8 ± 3.6 MPa below .1% elongation. The fracture surfaces show the expected failure mechanisms like pull‐out and crack deflection. The resulting fiber length in the printed samples is 140 µm in average.Keywords
Funding Information
- Sächsische Aufbaubank (100526196)
- Fonds National de la Recherche Luxembourg (INTER/MERA/19/13987285/CENTAUR)
This publication has 24 references indexed in Scilit:
- Additive Manufacturing of Fiber‐Reinforced Zirconia‐Toughened Alumina Ceramic Matrix Composites by Material Extrusion‐Based TechnologyAdvanced Engineering Materials, 2024
- Processing-microstructure correlations in material extrusion additive manufacturing of carbon fiber reinforced ceramic matrix compositesAdditive Manufacturing, 2023
- Material extrusion additive manufacturing of advanced ceramics: Towards the production of large componentsJournal of the European Ceramic Society, 2022
- A review on additive manufacturing of ceramic matrix compositesJournal of Materials Science & Technology, 2022
- Additive manufacturing of carbon fiber reinforced ceramic matrix composites based on fused filament fabricationJournal of the European Ceramic Society, 2022
- A multi-scale model for the effective electro-mechanical properties of short fiber reinforced additively manufactured ceramic matrix composites containing carbon nanotubesComposites Part C: Open Access, 2022
- All-oxide ceramic matrix composites (OCMC) based on low cost 3M Nextel™ 610 fabricsJournal of the European Ceramic Society, 2021
- Additive manufacturing of advanced ceramic materialsProgress in Materials Science, 2021
- Stereolithography-based additive manufacturing of lightweight and high-strength Cf/SiC ceramicsAdditive Manufacturing, 2020
- Faserverstärkte oxidkeramische WerkstoffeMaterialwissenschaft und Werkstofftechnik, 2007