Dynamic Mechanical Response, Cracking Behavior, and Stress Intensity Factors of Cement Mortar Specimens with Open and Closed Flaws
Open Access
- 27 February 2022
- journal article
- research article
- Published by Wiley in Shock and Vibration
- Vol. 2022, 1-15
Abstract
Major civil and military infrastructures are usually located in mountainous areas with complex geological structures. When subjected to impact loads caused by operational blasting or seismic activities, the inherent flaws or joints in the hosting rock mass may grow irreversibly and eventually and cause the entire structure to collapse. It is, therefore, desirable to understand the mechanical and cracking behaviors of flawed rock structures under dynamic loads. In this work, the cement mortar is used to make the plate specimens, and two different types of flaws, i.e., the open and the closed (resin-filled) flaws, with different inclination angles from 0° to 90° with respect to the loading direction are prefabricated. The nominal strength, crack initiation, and failure characteristics of the specimens under different loading rates are investigated using the split Hopkinson bar (SHPB) system in conjunction with the digital image correlation (DIC) technique. The results indicate that the dynamic nominal strength of both two types of specimens shows similar loading rate and flaw angle dependency, specifically, monotonically increasing with the increase of the loading rate while increasing first and then decreasing with increasing the flaw inclination angle. The strength of specimens with an open flaw is obviously lower than that of the specimens with a closed flaw at a similar loading rate. Besides, the failure mode of specimens with an open flaw is mainly an X-shaped tensile or tensile-shear mixed form regardless of the flaw inclination, whereas the resin-filled flawed specimens always fail in the form of an atypical X-shaped shear pattern with obvious randomness. Moreover, the stress field around the crack tip is carefully extracted based on the obtained displacement field from DIC analysis; the stress intensity factors at crack initiation onset also show flaw inclination- and loading rate-dependent behavior. The strength, cracking behavior, and stress field around the tip during the dynamic loading are closely related to the friction effect between the flaw surfaces. The findings in this work provide some basic insights into the cracking mechanism of rock with open and closed flaws under dynamic loading conditions.Keywords
Funding Information
- Natural Science Foundation of Hebei Province (E2020208071, CXZZSS2022085, 20203-ABC03B05, KF2020-08)
- Department of Education of Hebei Province (E2020208071, CXZZSS2022085, 20203-ABC03B05, KF2020-08)
- 03 special and 5G projects in Jiangxi Province (E2020208071, CXZZSS2022085, 20203-ABC03B05, KF2020-08)
- Open Research Topics of State Key Laboratory of Mechanical Behavior and System Safety of Traffic Engineering Structures (E2020208071, CXZZSS2022085, 20203-ABC03B05, KF2020-08)
This publication has 52 references indexed in Scilit:
- Crack Initiation, Propagation and Coalescence in Rock-Like Material Containing Two Flaws: a Numerical Study Based on Bonded-Particle Model ApproachRock Mechanics and Rock Engineering, 2012
- Measurement of mixed-mode stress intensity factors using digital image correlation methodOptics and Lasers in Engineering, 2012
- Suggested methods for determining the dynamic strength parameters and mode-I fracture toughness of rock materialsInternational Journal of Rock Mechanics and Mining Sciences, 2012
- Fracture mechanisms in soft rock: Identification and quantification of evolving displacement discontinuities by extended digital image correlationTectonophysics, 2011
- Crack initiation, propagation and coalescence from frictional flaws in uniaxial compressionEngineering Fracture Mechanics, 2010
- Crack propagation and coalescence in brittle materials under compressionEngineering Fracture Mechanics, 1998
- The mechanism of fracture coalescence in compression—experimental study and numerical simulationEngineering Fracture Mechanics, 1995
- Coalescence of fractures under shear stresses in experimentsJournal of Geophysical Research, 1995
- An experimental study of the strain field development prior to failure of a marble plate under compressionTectonophysics, 1990
- A theoretical and experimental evaluation of the Griffith theory of brittle fractureTectonophysics, 1971