Thin kerf cutting forces of frozen and non-frozen Norway spruce and Scots pine wood
Open Access
- 12 May 2021
- journal article
- research article
- Published by Taylor & Francis in Wood Material Science & Engineering
- Vol. 16 (6) , 414-420
Abstract
Reducing the kerf width in bandsawing has potential in reducing waste while optimising the yield. To be able to reduce the kerf width, understanding the cutting forces becomes critical. In this work, nine cutting teeth with varying band-body thicknesses and side clearances were tested by cutting both heartwood and sapwood of Norway spruce (Picea abies (L.) Karst.) and Scots pine (Pinus sylvestris L.) in frozen and non-frozen conditions. Single cutting teeth were moved into rotating wood samples in the 90–90° cutting direction, with chip thicknesses of 0.9 mm per cut. The main and normal cutting forces were measured. Scots pine had a higher density than Norway spruce and, therefore, a higher main cutting force. Non-frozen sapwood, non-frozen heartwood and frozen heartwood resulted in similar main cutting forces, but frozen sapwood resulted in significantly higher main cutting forces. Reducing the cutting width by about 45% resulted in an approximately 40% reduction in the main cutting force. The normal forces were not significantly affected by the species or cutting width. Frozen heartwood, non-frozen heartwood and non-frozen sapwood had similar normal cutting forces. Frozen sapwood had negative normal forces, and thus self-feeding was observed.Keywords
Funding Information
- Luleå University
This publication has 8 references indexed in Scilit:
- Effects of temperature and moisture content on selected wood mechanical properties involved in the chipping processWood Science and Technology, 2014
- The Effect of Wood Provenance and Density on Cutting Forces While Sawing Scots Pine (Pinus sylvestris L.)BioResources, 2014
- Cutting forces in bandsaw processing of oak and beech wood as affected by wood moisture content and cutting directionsEuropean Journal of Wood and Wood Products, 2013
- Tool wear effect on cutting forces: In routing process of Aleppo pine woodJournal of Materials Processing Technology, 2009
- Study of the properties of thirteen tropical wood species to improve the prediction of cutting forces in mode B.Annals of Forest Science, 2004
- Studies of the main cutting force at and near a cutting edgeEuropean Journal of Wood and Wood Products, 1993
- Principles of Wood Science and Technology1968
- An Analysis of the Wood-Cutting Process1958