Morphological structure and mechanical properties of In situ microfibrillar composites of modified PA66 with PP
Authors:
- 24 May 2012
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 127 (5) , 4044-4051
Abstract
In situ microfibrillar composites (PP/mPA66) of modified polyamide66 (mPA66) with polypropylene (PP) were prepared by using a “post‐compatibilization” technique. The mPA66 was firstly obtained by reactive extrusion of PA66 resin with a specially designed compatibilizer, which was then blended with PP through extrusion combined with a hot stretching and subsequently quenching process. The PP/mPA66 in situ microfibrillar composites were comparatively studied with simply blended samples of PP/PA66 that were prepared by blending PA66 and PP together with (or without) the same compatibilizer through extrusion. PA66‐g‐PP (and/or elastomers) graft copolymer formation in mPA66 was identified by dissolution test and infrared spectroscopy measurement, the compatibilizer is unevenly dispersed with large domains in PA66 as observed by scanning electron microscope (SEM). In PP/mPA66 composites, the in situ generated PA66 microfibrils have a rather nonuniform diameter distribution and a very rough surface. SEM observations for the fractured surface illustrated that PP/mPA66 composites have structural characteristics of stronger adhesion and moderate flexibility of the interface. Enhanced compatibilization between the PA66 microfibrils with the PP matrix resulted in improved mechanical properties of the PP/mPA66 composites. With optimized composition, the PP/mPA66 composite has notched Izod impact strength, flexural modulus, and tensile yield stress of 1.49, 1.16, and 0.99 times as those of the neat PP, respectively. Such enhanced mechanical properties balance and improved interface adhesion were not found in the simply blended samples of PP/PA66 with or without the specially designed compatibilizer. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013Keywords
This publication has 27 references indexed in Scilit:
- Contribution of Coalescence to Microfibril Formation in Polymer Blends during Cold DrawingJournal of Macromolecular Science, Part B, 2007
- Analysis of ceramics toughened by non-conventional fiber reinforcementMaterials Science and Engineering: A, 2007
- In situ microfibrillar‐reinforced composites of isotactic polypropylene/recycled poly(ethylene terephthalate) system and effect of compatibilizerJournal of Applied Polymer Science, 2006
- In‐Situ Fibrillation of Ny6/6 During Processing of PP/Ny6/6 Blends, Slightly Below the Ny6/6 Melting TemperatureJournal of Macromolecular Science, Part B, 2005
- Factors influencing the fiberization and mechanical properties of polypropylene/polyamide 66 in situ compositesPolymer International, 2003
- Reactive compatibilizer precursors for LDPE/PA6 blends. III: ethylene–glycidylmethacrylate copolymerPolymer, 2003
- From polymer blends to in situ polymer/polymer composites: Morphology control and mechanical propertiesPolymer Engineering & Science, 2002
- Healing of stress‐whitening in polyethylene and polypropylene at or below room temperaturePolymer Engineering & Science, 2000
- The effect of interfacial adhesion on the tensile behavior of polystyrene–glass‐bead compositesJournal of Applied Polymer Science, 1983
- Heterogeneous polymer systemsColloid and Polymer Science, 1970