Matthias Müller
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Matthias Müller has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Albert Albers
Institute of Product Development (IPEK), University of Karlsruhe, D‐76128 Karlsruhe, Germany
1 shared publicationHeiko Fettig
Institute of Product Development (IPEK), University of Karlsruhe, D‐76128 Karlsruhe, Germany
1 shared publicationOttmar Müller
Institute of Product Development (IPEK), University of Karlsruhe, D‐76128 Karlsruhe, Germany
1 shared publicationPascal Häußler
Institute of Product Development (IPEK), University of Karlsruhe, D‐76128 Karlsruhe, Germany
1 shared publicationThomas Schimmel
Institute of Applied Physics, University of Karlsruhe, D‐76128 Karlsruhe, Germany
1 shared publication
Latest Publications
- 24 April 2006
- Published by Wiley in Surface and Interface Analysis
- Vol. 38 (6) , 1090-1095
Finite element analysis of V‐shaped cantilevers for atomic force microscopy under normal and lateral force loads
For the quantitative investigation of surface properties such as elasticity, friction and wear by atomic force microscopy (AFM), a quantitative determination of the forces acting on the probe during its motion along the sample surface is essential. In this article, a fully parameterized finite element model for V‐shaped cantilevers is presented and the three‐dimensional mechanical deformations of the AFM cantilever are investigated. Force constants and detection angles for tip displacements in the three spatial directions are calculated for widely used cantilevers. The limits of linearity according to Hook's law are studied. It is found that the AFM contact cantilevers investigated here show a linear bending behavior for tip displacements within a range below approx. 10 nm in lateral directions and 100 nm in the normal direction. Displacements within this range are typical for many AFM applications including force modulation techniques. For higher loads as used e.g. for surface modification, a significant deviation from linear behavior is observed. Copyright © 2006 John Wiley & Sons, Ltd.
- 24 April 2006
- Published by Wiley in Surface and Interface Analysis
- Vol. 38 (6) , 1090-1095
Finite element analysis of V‐shaped cantilevers for atomic force microscopy under normal and lateral force loads
For the quantitative investigation of surface properties such as elasticity, friction and wear by atomic force microscopy (AFM), a quantitative determination of the forces acting on the probe during its motion along the sample surface is essential. In this article, a fully parameterized finite element model for V‐shaped cantilevers is presented and the three‐dimensional mechanical deformations of the AFM cantilever are investigated. Force constants and detection angles for tip displacements in the three spatial directions are calculated for widely used cantilevers. The limits of linearity according to Hook's law are studied. It is found that the AFM contact cantilevers investigated here show a linear bending behavior for tip displacements within a range below approx. 10 nm in lateral directions and 100 nm in the normal direction. Displacements within this range are typical for many AFM applications including force modulation techniques. For higher loads as used e.g. for surface modification, a significant deviation from linear behavior is observed. Copyright © 2006 John Wiley & Sons, Ltd.