In recent years, hydrocarbon ionomers, particularly sulfo-phenylated polyphenylenes (sPPP), have emerged as a potential competitor to established per-fluorinated sulfonic acid (PFSA) ionomers for both membrane and electrode applications. Compared to PFSA materials, sPPP ionomers exhibit much lower equivalent weights (EW), higher resistance to gas diffusion in bulk media, and significantly higher water uptake. Despite the promise of these materials, critical gaps in understanding of ionomer thin film properties and the ionomer-catalyst interface remain a barrier to wider deployment. Our group investigated thin film oxygen diffusion and sulfonic acid group adsorption for both sPPP and Nafion electrodes using oxygen transport resistance and CO displacement and stripping experiments. We report that for sPPP electrodes, local oxygen transport resistance, taken at 80% relative humidity (RH), is approximately one-third that corresponding to Nafion. We hypothesize that this difference is attributable to the bulky ionomer backbone, which may prevent preferential rearrangement over catalyst sites, similar to HOPI ionomers for PFSA. We also report that sPPP ionomers demonstrate a starkly different sulfonic acid group adsorption behavior than Nafion. While Nafion electrodes exhibit increased adsorption as relative humidity decreases, sPPP electrodes instead show a bell-shaped adsorption curve, with very low adsorption (~2%) at both dry and super-saturated conditions. This change in behavior between the ionomers is driven by the displacement charge, which is a result of the adsorbed sulfonic acid moieties being removed from the surface by adsorbing CO. Nafion electrodes exhibit a relatively flat displacement response while sPPP ionomers exhibit a bell-like shape with a maximum at 100% RH. We hypothesize that the cause of this difference for sPPP electrodes is driven by ionomer detachment from the surface of the catalyst at extreme hydration states. This is likely caused by a combination of higher dimensional swelling/shrinking with changing humidity as well as weaker attachment to the surface of the platinum due to the absence of fluorine on the polymer backbone. Further work, including computational studies, will be needed to investigate the ionomer configuration close to the catalyst surface.