Design of an On-Board ESD Protection for USB3 Applications
Authors:
- 27 October 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 16 (4) , 504-512
Abstract
This paper describes the development of an on-board system level protection for high-speed cable connections (e.g., USB3) with 15 kV robustness and a signal transfer rate of up to 10 Gb/s. A dedicated bipolar process is developed, on a high-resistive substrate with optimized diffusion profiles and a special via-on-via metallization to meet the capacitance target of 0.25 pF. The protection is shown to work well with several popular USB3 chipsets.Keywords
This publication has 10 references indexed in Scilit:
- Gun tests of a USB3 host controller board2016
- Overshoot-induced failures in forward-biased diodes: A new challenge to high-speed ESD design2013
- High-Robustness and Low-Capacitance Silicon-Controlled Rectifier for High-Speed I/O ESD ProtectionIEEE Electron Device Letters, 2013
- HMM–TLP correlation for system-efficient ESD designMicroelectronics Reliability, 2012
- Diode-Triggered Silicon-Controlled Rectifier With Reduced Voltage Overshoot for CDM ESD ProtectionIEEE Transactions on Device and Materials Reliability, 2011
- What Do We Know about Hydrogen-Induced Thermal Donors in Silicon?Journal of the Electrochemical Society, 2009
- Harmful voltage overshoots due to turn-on behaviour of ESD protections during fast transients2007
- Using an SCR as ESD protection without latch-up dangerMicroelectronics Reliability, 1997
- Effect of oxygen concentration on the kinetics of thermal donor formation in silicon at temperatures between 350 and 500 °CApplied Physics Letters, 1993
- A low-voltage triggering SCR for on-chip ESD protection at output and input padsIEEE Electron Device Letters, 1991