Error-sensitivity analysis for hypoid gears using a real tooth surface contact model
Authors:
- 9 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 231 (3) , 507-521
Abstract
Accurately and rapidly evaluated error sensitivity of actual tooth surfaces of hypoid gears can be a significant foundation for a variety of dynamic preference analysis and machine tool setting readjustments. Due to the complexity of local geometric features as well as the limitations of the data measurement on tooth surfaces of hypoid gears, automated error-sensitivity analysis for actual tooth surfaces still presents many substantial challenges. This paper presents a novel methodology for the error-sensitivity analysis of real tooth surfaces of hypoid gears. The methodology combines an error-sensitivity analysis model with a numerical analytical real tooth contact analysis (RTCA) model. The real tooth surfaces, describing local micro-geometry features on actual tooth surfaces, have been produced by 3D discrete data points reconstruction. In this method, the discrete data points on actual tooth surfaces are measured by using a coordinate measure machine (CMM). The location, size, and shape of contact patterns are determined from the predicted interference areas distribution by numerical analysis. In addition, the error-sensitivity analysis model is established for evaluation of the sensitivity of hypoid gears with real tooth surfaces that corresponds to misalignments. The results of experiment show that the proposed method can obtain actual contact properties that significantly improve the basic design performances significantly.Keywords
This publication has 15 references indexed in Scilit:
- Reverse engineering of machine-tool settings with modified roll for spiral bevel pinionsChinese Journal of Mechanical Engineering, 2013
- Ease-off based compensation of tooth surface deviations for spiral bevel and hypoid gears: Only the pinion needs correctionsMechanism and Machine Theory, 2013
- A load distribution model for hypoid gears using ease-off topography and shell theoryMechanism and Machine Theory, 2009
- Design and Manufacture of Spiral Bevel Gears With Reduced Transmission ErrorsJournal of Mechanical Design, 2009
- The study on the design of spiral bevel gear sets with circular-arc contact paths and tooth profilesMechanism and Machine Theory, 2008
- Higher-Order Tooth Flank Form Error Correction for Face-Milled Spiral Bevel and Hypoid GearsJournal of Mechanical Design, 2008
- Design, manufacture, stress analysis, and experimental tests of low-noise high endurance spiral bevel gearsMechanism and Machine Theory, 2006
- Fourth-Order Kinematic Synthesis for Face-Milling Spiral Bevel Gears With Modified Radial Motion (MRM) CorrectionJournal of Mechanical Design, 2005
- Gear Geometry and Applied Theory2004
- The Ultimate Motion GraphJournal of Mechanical Design, 1999