Understanding of the development of in-plane residual stress in sol-gel-derived metal oxide thin films
- 1 January 2012
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 111 (1) , 014901
Abstract
The in-plane residual stress in thin films greatly affects their properties and functionality as well as the substrate bending, and hence is an important factor to be controlled. In order to obtain general knowledge on the development of residual stress in sol-gel-derived oxide thin films, the in-plane residual stress was measured for yttria stabilized zirconia gel films on Si(100) wafers as a function of firing temperature by measuring the substrate curvature. The films showed a rather complex variation in residual stress, and the mechanism of the residual stress evolution was discussed, referencing the intrinsic stress and the x-ray diffraction data. At low annealing temperatures of 100–200 °C, the residual tensile stress decreased and became compressive partially due to the structural relaxation occurring during cooling. When the firing temperature was increased over 200 °C, the residual stress turned tensile, and increased with increasing annealing temperature, which was attributed to the increase in intrinsic stress due to film densification as well as to the reduced structural relaxation due to the progress of densification. The residual tensile stress slightly decreased at firing temperatures of 500–600 °C, which was attributed to the reduction in intrinsic stress due to thermally activated atomic diffusion as well as to emergence of thermal stress. At firing temperature over 600 °C, the residual tensile stress increased again, which was attributed to the increase in thermal stress generated during cooling due to the increased Young’s modulus of the film. Although appearing to be complicated, the whole variation of residual stress with firing temperature could be understood in terms of film densification, structural relaxation, atomic diffusion, progress of crystallization and thermal strain. The illustration presented in the work may provide a clear insight on how the residual stress could be developed in a variety of functional sol-gel-derived, crystalline oxide thin films.Keywords
This publication has 33 references indexed in Scilit:
- Variation in In‐Plane Stress during Densification and Crystallization of Titania Gel Coatings Deposited on Different Substrate SurfacesJournal of the American Ceramic Society, 2009
- Stress engineering of the alkoxide derived ferroelectric thin film on Si waferJournal of the Ceramic Society of Japan, 2009
- Stress evolution of sol–gel-derived silica coatings during heating: The effects of the chain length of alcohols as solventsThin Solid Films, 2009
- Development of residual stress in sol-gel derived Pb(Zr,Ti)O3 films: An experimental studyJournal of Applied Physics, 2008
- Evaluation of interfacial shear strength and residual stress of sol–gel derived fluoridated hydroxyapatite coatings on Ti6Al4V substratesEngineering Fracture Mechanics, 2007
- Residual stress effects on piezoelectric response of sol-gel derived lead zirconate titanate thin filmsJournal of Applied Physics, 2007
- Effects of Vacuum Ultraviolet Light Illumination on the Residual Stress in Sol–Gel-derived Titanium Dioxide FilmsChemistry Letters, 2006
- Thickness Dependence of Residual Stress in Alkoxide-Derived Pb(Zr0.3Ti0.7)O3 Thin Film by Chemical Solution DepositionJapanese Journal of Applied Physics, 2006
- Residual stress analysis in ferroelectric Pb(Zr0.52Ti0.48)O3 thin films fabricated by a sol-gel processApplied Physics Letters, 2003
- Calculated elastic constants for stress problems associated with semiconductor devicesJournal of Applied Physics, 1973