Mitigating Heat Accumulation Induced by Scan-Vector Shortening in Laser Powder Bed Fusion of Sharp-Edged Inconel 718 via Geometry-Informed Active Energy Modulation
Open Access
Abstract
Laser powder bed fusion (LPBF) enables the fabrication of geometrically complex metallic components, but sharp-edged features remain susceptible to localized heat accumulation because bidirectional meander scanning produces progressively shortened scanning vectors near acute apices. The resulting imbalance between repeated energy input and limited heat dissipation destabilizes melt-pool behavior and degrades surface integrity, densification and microstructural uniformity. In this study, a geometry-informed active energy modulation strategy was proposed for LPBF of Inconel 718 sharp-edged components. A dimensionless Power Reduction Factor (PRF) was formulated to couple laser power attenuation with scan-vector shortening. Coupled DEM–CFD simulations showed that power reduction in heat-accumulation-prone regions decreased peak temperature and suppressed excessive melt-pool expansion caused by adjacent-track thermal history. In situ coaxial photodiode monitoring revealed that apical heat accumulation intensified with i build height under insufficient power reduction, whereas increasing the PRF reduced the overheated zone. Among the tested conditions, PRF = 0.3 provided the most favorable balance between overheating and energy deficiency, minimizing apical surface roughness and maintaining a relatively uniform microhardness distribution above 290 HV0.1. Lower PRF values resulted in swelling and hardness degradation, while higher PRF values promoted track instability and lack-of-fusion defects. Microstructural characterization revealed a persistent intra-track hierarchy in a cellular dendritic scale, while location-dependent PDAS variations along the sharp-edged region were comparatively modest. The observed trends indicate that spatially graded power attenuation modifies local cellular-scale heterogeneity. These results demonstrate that PRF-based modulation provides a quantitative route for mitigating scan-vector-shortening-induced heat accumulation in sharp-edged geometries without additional cooling delays.Keywords
This publication has 22 references indexed in Scilit:
- Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verificationThe International Journal of Advanced Manufacturing Technology, 2024
- Dislocation Distribution, Crystallographic Texture Evolution, and Plastic Inhomogeneity of Inconel 718 Fabricated by Laser Powder Bed FusionAdvanced Engineering Materials, 2024
- Experimental and numerical comparison of heat accumulation during laser powder bed fusion of 316L stainless steelProgress in Additive Manufacturing, 2022
- A novel paradigm for feedback control in LPBF: layer-wise correction for overhang structuresAdvances in Manufacturing, 2022
- Numerical and analytical investigation on meltpool temperature of laser-based powder bed fusion of IN718International Journal of Heat and Mass Transfer, 2021
- Mesoscopic-scale numerical investigation including the influence of scanning strategy on selective laser melting processComputational Materials Science, 2021
- Scanning strategy in selective laser melting (SLM): a reviewThe International Journal of Advanced Manufacturing Technology, 2021
- On-line melt pool temperature control in L-PBF additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2021
- Multi-physics modelling of molten pool development and track formation in multi-track, multi-layer and multi-material selective laser meltingInternational Journal of Heat and Mass Transfer, 2020
- Influence of scanning length and energy input on residual stress reduction in metal additive manufacturing: Numerical and experimental studiesJournal of Manufacturing Processes, 2020