High Efficiency in Clean Hydrogen Production Using Water and AlLi Phases Prepared by Mechanical Alloying
Open Access
- 9 December 2024
- Vol. 5 (4) , 987-1003
Abstract
In this work, the results of clean hydrogen production from the direct chemical reaction between aluminum–lithium compounds and distilled water under normal conditions, without additives or catalysts, are presented. The material was prepared by mechanical alloying using a high-energy Spex-type mill in an Al20Li ratio. Relatively short milling times were programmed for the preparation of AlLi phases. Through this process, two phases (AlLi and Al8.9Li1.1) were identified, which react efficiently to produce clean hydrogen. The experiments demonstrate fast and self-sustained reactions between AlLi phases and distilled water. In both the phase preparation and hydrogen generation, 100% efficiency was achieved. The hydrolysis reaction occurred quickly, and the hydrogen volume generated was 1700 mL/g of material. Under these conditions, aluminum generates 1390 mL of hydrogen, and lithium generates 310 mL/g from both AlLi phases. A single by-product (LiAl2(OH)7·2H2O) was identified. According to the results and the conditions applied in this research, the hydrogen produced does not require prior purification and can therefore be used directly in fuel cells. The AlLi–water reaction is a promising process for generating hydrogen in a simple and relatively short time compared to other hydrogen production methods. In this process, no greenhouse gas emissions were produced.Keywords
This publication has 62 references indexed in Scilit:
- Effect of low concentration hydroxides on Al hydrolysis for hydrogen productionEnergy, 2023
- Industrial furnaces with thermochemical waste-heat recuperation by coal gasificationEnergy, 2021
- Behavior of a hydrotalcite type material obtained from MgAl alloy for CO2 adsorptionApplied Clay Science, 2019
- Hydrogen generation from the reaction of Al-based composites activated by low-melting-point metals/oxides/salts with waterEnergy, 2019
- Hydrogen production by ultrasound assisted liquid laser ablation of Al, Mg and Al-Mg alloys in waterApplied Surface Science, 2019
- Experimental researches on hydrogen generation by aluminum with adding lithium at high temperatureEnergy, 2015
- Effect of salts addition on the hydrogen generation of Al–LiH composite elaborated by ball millingEnergy, 2015
- Experimental study on the effect of low melting point metal additives on hydrogen production in the aluminum–water reactionEnergy, 2015
- Hydrogen generation by splitting water with Al-Li alloysInternational Journal of Energy Research, 2012
- Hydrolytic Hydrogen Generation Using Milled Aluminum in Water Activated by Li, In, and Zn AdditivesFuel Cells, 2012