Redefining the Channel Bandwidth for Simultaneous Wireless Power and Information Transfer
- 21 July 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 69 (7) , 6881-6891
Abstract
The ideal simultaneous wireless power and information transfer (SWPIT) system should share the same source and channel bandwidth. However, the requirements of the channel bandwidth between wireless power transfer (WPT) and wireless information transfer are different. In order to alleviate the effect of communications on the WPT, three bandwidths are redefined based on traditional communication systems, namely the modulation bandwidth, channel bandwidth and demodulation bandwidth. A square wave circuit is built to track the frequencies of signals at the receiver power coil, and the harmonic components in the same square wave are used to recreate information source to transmit data. Since the harmonic components can enlarge the deviations of the fundamental component, the needed channel bandwidth is decreased. The transmitter power coil and the receiver power coil still work under the quasi-resonant state with online communications. The communication function shows a strong immunity to various disturbances, such as distances, loads and input voltages. Based on the proposed method, two typical SWPIT systems in near-field and far-field are built, and the experimental data are consistent with the analytical results. The proposed SWPIT achieves a good tradeoff between efficiency and data transfer rate.Keywords
Funding Information
- National Natural Science Foundation of China (51777098)
- Natural Science Foundation of Jiangsu Province (BK20191383)
- Green and Blue Project in Jiangsu Province
This publication has 28 references indexed in Scilit:
- High Data-Rate Communication in Near-Field RFID and Wireless Power Using Higher Order ModulationIEEE Transactions on Microwave Theory and Techniques, 2016
- Wireless Power Transfer With Automatic Feedback Control of Load Resistance TransformationIEEE Transactions on Power Electronics, 2015
- The Parallel Transmission of Power and Data With the Shared Channel for an Inductive Power Transfer SystemIEEE Transactions on Power Electronics, 2015
- Wireless Power and Data Transfer via a Common Inductive Link Using Frequency Division MultiplexingIEEE Transactions on Industrial Electronics, 2015
- Joint Transmit Beamforming and Receive Power Splitting for MISO SWIPT SystemsIEEE Transactions on Wireless Communications, 2014
- 0.56 V, –20 dBm RF-Powered, Multi-Node Wireless Body Area Network System-on-a-Chip With Harvesting-Efficiency Tracking LoopIEEE Journal of Solid-State Circuits, 2014
- Antennas and circuits for ambient RF energy harvesting in wireless body area networks2013
- Design and Optimization of Resonance-Based Efficient Wireless Power Delivery Systems for Biomedical ImplantsIEEE Transactions on Biomedical Circuits and Systems, 2010
- High-Speed OQPSK and Efficient Power Transfer Through Inductive Link for Biomedical ImplantsIEEE Transactions on Biomedical Circuits and Systems, 2010
- Simple and efficient inductive telemetry system with data and power transmissionMicroelectronics Journal, 2007