BPD-Free Dicing of Epitaxial SiC Wafers Using Water Jet Guided Laser
Open Access
- 21 May 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1193, 77-82
Abstract
Silicon carbide (SiC) wafers are essential for next-generation power devices, however conventional dicing methods often induce cracks and Basal Plane Dislocations (BPDs), reducing device reliability. This study demonstrates BPD-free dicing of epitaxial SiC wafers using Water jet Guided Laser (WGL) processing. Full-thickness cutting was performed on 350 μm-thickness wafers with a 10 μm-thickness epitaxial layer using a YAG laser (532 nm wavelength, 200 ns pulse width, 10 kHz repetition rate, 30–80 W output) on an LB300 system. BPD evaluation was carried out by X-ray topography (XRT) with the-1-128 reflection before and after cutting. The results showed no generation or propagation of new BPDs, and pre-existing BPDs did not glide, confirming that WGL processing enables BPD-free machining. These results are attributed to the ablation-based nature of WGL with water assistance, which avoids mechanical stress on epitaxial SiC wafers.Keywords
This publication has 4 references indexed in Scilit:
- Proposal of Damage-Free SiC Wafer Dicing Using Water Jet Guided LaserMaterials Science Forum, 2024
- Thermal Laser Separation – A Novel Dicing Technology Fulfilling the Demands of Volume Manufacturing of 4H-SiC DevicesMaterials Science Forum, 2015
- DiscussionEuropean Business Law Review, 2006
- Degradation of hexagonal silicon-carbide-based bipolar devicesJournal of Applied Physics, 2006