Heat Transfer Measurements On Unequally Loaded Underground Power Cables With Constant And Cyclic Currents
Authors:
- 1 October 1984
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Apparatus and Systems
- Vol. PAS-103 (10) , 2799-2806
Abstract
A test site was constructed with underground power cables in a typical distribution-type duct bank arrangement. The site can be used to obtain temperatures throughout the duct bank and surrounding soil medium for known cable currents. A personal computer with an analog to digital converter system is used to independently set the currents in each cable to any load so that steady, cyclic, and transient experiments can be performed. Results of a number of constant and cyclic current experiments show good agreement between experimental temperature data and the calculated temperatures from an ampacity computer program.Keywords
This publication has 8 references indexed in Scilit:
- Optimization of Ampacities for Unequally Loaded Underground Power CablesIEEE Transactions on Power Apparatus and Systems, 1982
- Experimental Investigation of the Ampacity of Distribution Cables in a Duct Bank with and without Forced CoolingIEEE Transactions on Power Apparatus and Systems, 1981
- Effective Thermal Resistivity for Power Cables Buried in Thermal BackfillIEEE Transactions on Power Apparatus and Systems, 1979
- Experimental Installation of 69-kV Synthetic-Insulated Underground Cables and ComponentsIEEE Transactions on Power Apparatus and Systems, 1970
- The Thermal Behavior of Cable Backfill MaterialsIEEE Transactions on Power Apparatus and Systems, 1968
- Thermal Characteristics of Two Types of Concrete Conduit InstallationsIEEE Transactions on Power Apparatus and Systems, 1967
- Long-Time Heat Runs on Underground Cable in a Sand HillTransactions of the American Institute of Electrical Engineers. Part III: Power Apparatus and Systems, 1960
- The calculation of the temperature rise and load capability of cable systemsTransactions of the American Institute of Electrical Engineers. Part III: Power Apparatus and Systems, 1957