Effect of Mg content on the dimensional stability and tensile properties of heat treated Al-Si-Cu (319) type alloys
Authors:
- 1 September 1997
- journal article
- research article
- Published by Taylor & Francis in International Journal of Cast Metals Research
- Vol. 10 (2) , 67-78
Abstract
The present study was performed on A319.2 aluminum alloy containing 6.2% Si, 3.46% Cu, 0.35% Fe, 0.1% Mg. Small amounts of additives were added to the molten metal as follows: 0.5% Mg, (0.5%Mg + 0.03% Sr), (0.5%Mg + 0.03% Sr + 0.02% TiB2). The fluidity of the molten metal as a function of temperature in the range 620–740 °C was measured using the Ragone testing technique. Two solution treatments were applied to test bars prepared from these alloy compositions: 6–8 h at 470 °C, and 6–8 h at 505 °C. In both cases, the test bars were quenched in hot water (60 °C), followed by immediate ageing for 5 h at 180 °C. The results reveal that Sr slightly improves the fluidity of the molten metal (∼12%) at 720 °C. The addition of Mg leads to a noticeable increase in the alloy length (∼2%) when the solution temperature is above 500 °C. At this temperature, incipient melting of Al5Mg8Si6Cu2 and Al2Cu phase particles located at the grain boundaries was significant. Ageing at 180 °C contributes significantly to the alloy strength without much change in the dimension. The magnitude of the increase in alloy strength is strongly related to the solution temperature. Solution treatment for 8–10 h at 500 °C may be recommended.Keywords
This publication has 6 references indexed in Scilit:
- Solution heat treatment of 319 aluminium alloy containing ~0.5 wt% Mg. Part 2—microstructure and fractographyInternational Journal of Cast Metals Research, 1996
- Microstructural aspects of the dissolution and melting of Al2Cu phase in Al-Si alloys during solution heat treatmentMetallurgical and Materials Transactions A, 1996
- Dissolution of iron intermetallics in Al-Si Alloys through nonequilibrium heat treatmentMetallurgical and Materials Transactions A, 1995
- Heat treatment of 319.2 aluminium automotive alloy Part 2, Ageing behaviourCast Metals, 1995
- Heat treatment of 319.2 aluminium automotive alloy Part 1, Solution heat treatmentCast Metals, 1995
- Dimensional changes in heat treating aluminum alloysMetallurgical Transactions A, 1980