Effects of Variations of Carbon, Sulfur and Phosphorus on the Corrosion Behavior of Alloy 600
Authors:
- A. R. McIlreeAMA. R. McIlree
- H. T. MichelsHMH. T. Michels
- 1 December 1975
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 31 (12) , 441-448
Abstract
Corrosion tests were conducted on a series of Ni-Cr-Fe heats with C, S, and P varied within the composition range of alloy 600. The materials were in several conditions of heat treatment. Stress corrosion cracking (SCC) tests were conducted in undeaerated and deaerated water and deaerated 50% NaOH, all at 316 C (600 F). Intergranular corrosion tests were conducted in boiling 65% nitric acid and ferric sulfate-sulfuric acid solutions. In 8000-hour deaerated water tests, all materials were resistant to stress corrosion cracking (SCC). In undeaerated water and in deaerated 50% NaOH, all materials showed intergranular attack. Corrosion rates in boiling 65% nitric acid and ferric sulfate-50% sulfuric acid increased with increased carbon and sulfur levels. Some of the test coupons corroded uniformly and intergranularly during the ferric sulfate-50% sulfuric acid exposure. Reducing the sulfuric acid concentration and increasing the ferric sulfate concentration caused intergranular corrosion of carbon and phosphorus containing materials, while sulfur acted to decrease the deleterious effects of carbon and phosphorus. In addition, a grain size effect was revealed in the ferric sulfate-50% sulfuric acid exposure. Structural investigations showed carbon and phosphorus could be redistributed by heat treatment and were generally associated with M7C3 and Ti(C,N) particles. High sulfur heats contained sulfur-rich particles which were located both within the grain and on grain boundaries. The way in which these residual elements influence intergranular corrosion is discussed.Keywords
This publication has 5 references indexed in Scilit:
- Predicting Corrosion Rates with the PotentiostatCorrosion, 1972
- A new type of stress-strain curve and the Portevin-Le Chatelier effect in Au (14 at.% Cu)Acta Metallurgica, 1972
- Effect of Some Environmental Conditions on Stress Corrosion Behavior of Ni-Cr-Fe Alloys in Pressurized WaterCorrosion, 1968
- Influence of Sulfur on the Corrosion Resistance of Austenitic Stainless SteelCorrosion, 1967
- The Effect of Composition and Structure on the Electrochemical Reactivity of NickelJournal of the Electrochemical Society, 1965