Temperature‐dependence improvement for a MEMS gyroscope using triangular‐electrode based capacitive detection method
Authors:
Open Access
- 1 November 2017
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in Micro & Nano Letters
- Vol. 12 (11) , 828-833
Abstract
This work presents analysis and test results on temperature‐dependence improvement for a microelectromechanical systems (MEMS) gyroscope based on triangular‐electrode based (TEB) capacitive detection method. To reduce the effects of temperature variations on MEMS gyroscopes, TEB capacitive detection method is applied because the extracted amplitude and phase are robust to system parameter fluctuations. In the first place, analytical results for the scale factors and zero‐rate outputs, respectively, utilising linear electromechanical amplitude modulation (linear‐EAM) method and TEB method are derived. Then experimental results of the temperature characteristics for gyroscopes are conducted. The temperature coefficient of scale factor over the temperature range of −10 to 60°C is reduced from −8845 ppm/°C for linear‐EAM method to 1660 ppm/°C for TEB method with an improvement factor of 5.3. Moreover, the temperature‐induced zero‐rate output variation is decreased from −68.05°/s for linear‐EAM method to −29.09°/s for TEB method with an improvement factor of 2.3. Experimental results of temperature‐dependence improvement agree well with the theoretical analysis. In the end, Allan variance analysis demonstrates a bias instability of 2.85°/h, and an ARW (angle random walk) of 0.16°/√h with a vacuum‐packaged gyroscope using TEB method, which is significantly better than the bias instability 5.47°/h and ARW 0.22°/√h tested using linear‐EAM method.Keywords
This publication has 10 references indexed in Scilit:
- A temperature characteristic research and compensation design for micro-machined gyroscopeModern Physics Letters B, 2017
- A novel triangular-electrode based capacitive sensing method for MEMS resonant devicesSensors and Actuators A: Physical, 2016
- One-time frequency sweep to eliminate IQ coupling in MEMS vibratory gyroscopes2016
- Digital drive closed-loop with gain compensation for micro-machined gyroscopeOptics and Precision Engineering, 2014
- Compensation of drifts in high-Q MEMS gyroscopes using temperature self-sensingSensors and Actuators A: Physical, 2013
- 1 PPM precision self-calibration of scale factor in MEMS Coriolis vibratory gyroscopes2013
- A Characterization of the Performance of a MEMS Gyroscope in Acoustically Harsh EnvironmentsIEEE Transactions on Industrial Electronics, 2010
- Online self-compensation for enhanced the scale factor stability of a micromachined gyroscopeJournal of Physics: Conference Series, 2009
- Temperature Dependence of Quality Factor in MEMS ResonatorsJournal of Microelectromechanical Systems, 2008
- Error Sources in In-Plane Silicon Tuning-Fork MEMS GyroscopesJournal of Microelectromechanical Systems, 2006